FOVNO ES-L04 사용 설명서 - 페이지 5

{카테고리_이름} FOVNO ES-L04에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FOVNO ES-L04 16 페이지. Electric crossbars rack

Introduction

Alarm System Instructions

1. Your luggage bars rack is ﬁtted with a safety alarm which will alert you if the back loses its connection with the vehicle.

The alarm will sound if a suction foot leaks. In the even of this happening the N-Power system will automatically attempt

to create a vacuum seal using the built in pump.

2. The alarm module is ﬁtted with a standard USB which can be connected to your vehicle either via the vehicles own USB, a

USB adaptor or USB port on a sound system. The alarm will connect to the N-Power box wirelessly and will alert you in the

even of a pressure error. Double sided toe on the underside of the alarm can be used to hold it in place.

3. PLEASE NOTE: If you are using more than one electric crossbars rack system on your vehicle the alarm system may not

operate correctly due to a shared signal. While the alarm may not operate the N-Power box will still function as normal.

N-Power Control Box Functions

· Charging: Charging the N-Power box is easy and thanks to the USB C connector you can charge from a phone charger

power band or a USB charger. Simply remove the waterproof / dust cover and charge with the included USB C wire.

· The N-Power control box features USB lights that tell you the level of charge in the battery. An orange light indicates the

system needs charging, blue means full and a red light indicate the system is being charged. To check the battery level press

the button on the N-Power control box.

Note: The charging voltage is 5V, if it exceeds this range, it will aﬀect the charging or damage the charging module.

Quick release air hose connection

USB Type-C connector

(Red light when charging blue

light when fully charged)

Dust seal plug

Power button

Battery health check button

(Dust seal: When the rack is not in use

please use the dust seal to protect the

pneumatic connections.)

N-Power Control Box

Pairing

Pairing method of alarm and control box

1. Clear data: There is a small hole on the back of the

alarm that is a button for the pairing switch. After the

alarm is connected to the power supply, press the

switch button in the small hole for about 10 seconds.

When the indicator light of the alarm is oﬀ, it means

that the original data is cleared.

2. Use the same method to press the switch button in

the small hole of the alarm for about 3-5 seconds. After

the alarm indicator lights up, start the control box, and

then stop pressing the pairing switch. At this time, the

red orange blue

blue blue

alarm buzzes, the pairing is complete.

(Blue light-normal, red and orange

light-charging instantly)

A button for the pairing switch

Alarm

The underside of the alarm