FOVNO RS-03B2 사용 설명서 - 페이지 7

{카테고리_이름} FOVNO RS-03B2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FOVNO RS-03B2 10 페이지. Sucker bike rack

Rear suction foot installation method

Clean up the suction foot and car surface with wet towel, be careful not to leave too much water to

avoid the suction foot sliding oﬀ. Put it on the chosen place. Then press the suction foot vertically

against the car roof with one hand while the other hand pushes the cylinder rod to extract the air

until the white line is in the pump and make sure there is no obvious sign of rebound from the

cylinder rod.

Place the rear wheel on the suction foot and bind the crank strap.

Press the cylinder rod

Fix the rear wheel

Vertical placed

Remove the roof rack

After using, remove it from the edge of the suction foot by hand to allow air to enter the suction foot.

Attention

1. Place cylinder rod toward the rear of the vehicle to avoid the wind and dust entering into the cylinder rod.

2. Check carefully whether the front fork of the bicycle is ﬁrmly locked with the fork clamp of the roof rack.

3. Make the bike parallel to the car body to reduce wind resistance.

4. Equipped with standard accessories, please purchase separately if you need non-standard accessories.