3M Dynapro ET 350L3 설치 매뉴얼 - 페이지 4

{카테고리_이름} 3M Dynapro ET 350L3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Dynapro ET 350L3 7 페이지. Nema 4x hatch
3M Dynapro ET 350L3에 대해서도 마찬가지입니다: 설치 매뉴얼 (6 페이지)

페이지 인쇄

Installing the NEMA 4X Hatch

Connecting supplied sealed fittings

Make clearance hole. Clearance hole can be

made anywhere on the back of the hatch, as long

as the hatch can open and close freely on its

hinges after the cables and/or cable fittings are

installed.

The number of holes needed will depend on

whether your ET 350 has a KVM extender

(maximum of four holes) or not (three holes).

Table B shows the clearance holes required in

each case

: There are three indentations on the back of

Note

the hatch that may be used as a guide when

creating holes. However, these are only guides; if

you need four holes, you will need to decide how

best to space them.

Table B: Cable clearance holes required for ET 350

units without and with KVM extender

Opening

ET 350 monitor

for this

without

cable

KVM extender

Power

Serial

VGA

CAT5

Mouse

Keyboard

Important

If the diameter of the cable is close to the ranges of both

the small and large fittings shown in Table A, try running

the cable through the smaller fitting before beginning to

connect the fittings. If the cable will go through the small

fitting without being forced, 3M Touch Systems

recommends using that fitting.

19504 (Rev. 1.1)

ET 350 monitor

with

KVM extender

3M Dynapro ET 350 Monitor (Models ET 350R and ET 350L3)

The cable fitting comes loosely assembled.

Disassemble the cable fitting into its four

components: locking nut, o-ring, body hex

(which encloses the compression sleeve), and

sealing nut.

Install the o-ring onto the surface of the body hex

and then insert the body hex (with o-ring

attached) into the clearance hole on the outside

of the hatch.

On the inside of the hatch, attach the locking nut

to the body hex.

Holding the body hex stationary with a wrench,

hand-tighten the locking nut and then use a

second wrench to tighten the locking nut until the

cable fitting is held in place securely (see

Table A for suggested torque values).

Slide the sealing nut onto the cable and then,

from the outside of the hatch, feed the cable

through the cable fitting.

Gently screw the sealing nut onto the body hex,

but do not tighten it. Leave the sealing nut loose

to allow the cable to move through the fitting.

Slide the cable through the body hex and into the

hatch until you are satisfied with the amount of

cable inside and outside of the hatch.

Make sure there is enough slack in the cable to

allow the hatch to fully open and close on its

hinges without straining the cables or connectors.

Page 4