3M Dynapro ET 350LS 설치 매뉴얼 - 페이지 5

{카테고리_이름} 3M Dynapro ET 350LS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Dynapro ET 350LS 6 페이지. Nema 4x hatch

10. Using a wrench on the body hex, make sure that the

cable fitting still is tightly screwed into the hatch.

11. Insert the hinge pins of the hatch into the hinges of the

ET unit, close the hatch and make sure that the screw

holes in the edges of the hatch line up with the

threaded holes in the unit's enclosure.

Important

If you need to examine cables inside the access hatch, take off

the removable plate (or extended hatch cover) from the hatch.

Closing the hatch

To close the hatch, follow these steps:

1. Attach cables to their respective connectors.

2. Close and fasten the hatch by loosely attaching the

four #6-32 Phillips screws.

3. Using a No. 1 Phillips torque screwdriver, gradually

tighten diagonal pairs until all the screws are equally

tight at a torque of 7 inch-pounds. This may require

about three rounds of tightening.

3M Dynapro ET 350 Monitors (Models 350R and 350L3) and ET 3170 Terminal

Replacing cables

To replace a cable, disassemble the fitting by following

these steps:

1. Using a wrench to hold the body hex stationary,

2. Grip the disconnected cable and pull while turning the

The new cable you install will require a new fitting.

3M Touch Systems Proprietary Information

loosen the sealing nut with a second wrench.

cable in a counter-clockwise direction.