DAINCUBE DMC-L 하드웨어 사용 설명서 - 페이지 2
{카테고리_이름} DAINCUBE DMC-L에 대한 하드웨어 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAINCUBE DMC-L 15 페이지. Embedded based motion controller optimized for industrial robots, arm cortex-a9 linux system
Copyright notice
Copyright © 2005–2019 Daincube
Copying of this document, and giving it to others and the use or communication of the Contents thereof, is
forbidden without express authority. Offenders are liable to the payment of damages.
All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
Important information
This documentation is intended for qualified audience only. The product described herein is not an end user
product. It was developed and manufactured for further processing by trained personnel.
Disclaimer
Although this document has been generated with the utmost care no warranty or liability for correctness or
suitability for any particular purpose is implied. The information in this document is provided "as is" and is
subject to change without notice.
Trademarks
All used product names, logos or trademarks are property of their respective owners.
Product support
DAINCUBE Corp.
Web: www.daincube.com
E - MAIL: [email protected]
Safety precautions
Be sure to observe all of the following safety precautions.
Strict observance of these warning and caution indications are a MUST for preventing accidents, which
could result in bodily injury and substantial property damage. Make sure you fully understand all definitions
of these terms and related symbols given below, before you proceed to the manual.
Symbols
The following symbols may be used in this specification:
⚠
Warning
Warnings indicate conditions that, if not observed, can cause personal injury.
⚠
Caution
Cautions warn the user about how to prevent damage to hardware or loss of data.
✏
Note
Notes call attention to important information that should be observed.
DAINCUBE Corp.
Preface
. All rights reserved.
DMC-L hardware user's manual
2 / 14