DAINCUBE DTP7H 매뉴얼 매뉴얼 - 페이지 5

{카테고리_이름} DAINCUBE DTP7H에 대한 매뉴얼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAINCUBE DTP7H 6 페이지. Uwf

1. Introduction

This document is a manual on how to use UWF function of DTP10-P. UWF is a Unified Write Filter that

protects physical storage media, including most standard writable storage (such as HDD) supported by the OS.

This document enables or disables UWF.

2. UWF enable and protect "C" drive

2.1. UWF enable

The default settings are shipped with UWF enabled. Therefore, the following items may be omitted, but please

follow the procedure below when disabling and re-activating UWF.

Power on the DTP10-P, boot it, and run the command prompt as an administrator.

"Click the Start button -> cmd -> Command Prompt -> right mouse click -> Run as administrator"

Enter the command at the bottom and reboot.

uwfmgr.exe filter enable

2.2. "C" drive protection settings

Before protecting the C drive, store the applications that the user needs to protect in advance on the C drive.

If you protect the C drive without saving it, the user application will be lost when you reboot. Be sure to save

the user application to the C drive before setting the C drive for protection.

After saving the user application, run the command prompt as administrator to protect the C drive.

Power on the DTP10-P, boot it, and run the command prompt as an administrator.

"Click the Start button -> cmd -> Command Prompt -> right mouse click -> Run as administrator"

After entering the command at the bottom and rebooting, the process of setting C drive protection is finished.

uwfmgr.exe volume protect c:

3. Disable UWF function and unprotect "C" drive

3.1. "C" drive unprotect settings

If the UWF feature is enabled and C drive protection is enabled, you must first disable the C drive protection

setup.

Power on the DTP10-P, boot it, and run the command prompt as an administrator.

"Click the Start button -> cmd -> Command Prompt -> right mouse click -> Run as administrator"

Enter the command at the bottom and reboot.

uwfmgr.exe volume unprotect c:

3.2. UWF disable

Disable the C drive protection setting and disable the UWF function.

Power on the DTP10-P, boot it, and run the command prompt as an administrator.

"Click the Start button -> cmd -> Command Prompt -> right mouse click -> Run as administrator"

Enter the command at the bottom and reboot.

uwfmgr.exe filter disable

DAINCUBE

Corp.

DTP10-P UWF Guide Manual

5 / 6