DS18 JK-HARNESS 사용자 설명서 - 페이지 15

{카테고리_이름} DS18 JK-HARNESS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DS18 JK-HARNESS 16 페이지.

A. RGB LED light wire: connect this to each RGB LED lighting such as

speakers, rings, grills, tweeters, and DS18 Badge used for the soundbar.

B. Factory dome light connector: connect this to the OEM dome lamp

(not included).

C. Factory Soundbar Connector: connect this to the OEM connector for the

Soundbar.

D. 12 pin Harness Connector: this goes to the DS18 roof harness from the

amplifier side.

1. Speaker 1 connector: connect this to the speaker, Green: +, Green/Black: -

2. Speaker 2 connector: connect this to the speaker White: +, White/Black: -

3. Speaker 3 connector: connect this to the speaker Gray: +, Gray/Black: -

4. Speaker 4 connector: connect this to the speaker Violet: +, Violet/Black: -

5. Tweeter and Driver Wires: connect this to each tweeter and driver, Gray: +,

Gray/Black: -

Final Steps:

1. Run the positive power wire to the front battery under the hood, you can use

the existent drain caps on the floor in the seat area to pass through the wire

and route it to the battery.

2. Secure the wire use zip-ties to the chassis or factory harness nearby and keep

it far away from the header/exhaust.

3. Connect it on the Positive (+) terminal of the battery and secure the fuse

holder in an accessible area using screws or zip-ties.

4. Once all is connected, put back the seat and make sure all connectors are

plugged-in so you can re-connect the negative post (Ground) of the battery.

5. Turn on the Radio and check sound making sure that all speakers are playing,

then adjust the amplifier's gain and crossover point to your preference.

6. This should be all! Enjoy your new DS18 JK-HARNESS.