DS18 JL- HARNESS 사용자 설명서 - 페이지 7

{카테고리_이름} DS18 JL- HARNESS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DS18 JL- HARNESS 8 페이지.

Soundbar Side

A - Sound Bar Connector: this goes outside the soundbar and allows us to

connect and disconnect it for any service, speaker replacement or

facilitate the installation.

B - RGB LED light wire: connect this to each RGB LED lightings such

as speakers, rings, grills, tweeters, and DS18 Badge used for the

Soundbar.

Black: +12V, Red: Red color (-), Green: Green color (-), Blue:

Blue color (-).

C - Speaker Wires: connect these wires to each speaker in the soundbar

like this:

Speaker 1 and Tweeter 1 connected in parallel to the wire: White: (+),

White/Black: (-)

Speaker 2 and Tweeter 2 connected in parallel to the wire: Green: (+),

Green/Black: (-)

Speaker 3 and Tweeter 3 connected in parallel to the wire: Gray: (+),

Gray/Black: (-)

Speaker 4 and Tweeter 4 connected in parallel to the wire: Violet: (+),

Violet/Black: (-)

*Always use the bass blocker (filter) on each tweeter to avoid burning it.

FINAL STEP

1. Run the positive power wire to the front battery under the hood, you can

use the existent drain caps on the floor in the seat area to pass through

the wire and route it to the battery

2. Secure the wire use zip-ties to the chassis or factory harness nearby and

keep it far away from the header / exhaust.

3. Connect it on the Positive (+) terminal of the battery and secure the fuse

holder in an accessible area using screws or zip-ties.

4. Once all is connected, put back the seat and make sure all connectors

are plugged-in so you can re-connect the negative post (Ground) of

the battery.

5. Turn on the Radio and check sound making sure that all speakers are

playing, then adjust the amplifier's gain and crossover point to your

preference.

6. Enjoy your new DS18 JL-HARNESS.