DS18 EXL-P4000X1D 소유자 매뉴얼 - 페이지 13

{카테고리_이름} DS18 EXL-P4000X1D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DS18 EXL-P4000X1D 20 페이지. Competition monoblock subwoofer amplifier

EXL-P

INSTALLATION

DAISY CHAIN

Daisy chain connection allows linking of 2 same amplifiers to work as 1 single amplifier.

Please read the following connection diagram cautiosly to ensure the correct connection.

Step 1. Connec the master amplifier to the head unit

Step 2. Connect the master slave amplifier in daisy chain RCA jack as shown in the

diagram.

Step 3. Connect speaker cable (+) on master amplifier to subwoofer (+)

Step 4. Connect speaker cable (+) on slave amplifier to subwoofer (-)

Step 5. Connect speaker cable (-) on master amplifier to speaker cable (-) on slave

amplifier using 8 AWG wire cable.

The minimum impedance as 1 unit is 1 Ohm.

In a daisy chain configuration the minimum impedance is 2 Ohm.

CAUTION

Before attempting to make any connections to power supply, input and output

connectors, make sure the amplifier is in OFF state. Check polarity of cables carefully

as using reversed polarity will cause damage to the amplifier. And to prevent power

loss and overheating of wiring, always use the recommended wire gauges.

CAUTION

Installation of the amplifier should be done in the following steps:

1. Ensure that the ground is appropiate, then connect i to the amplifier.

2. Next step is to connect the +12V wire. Ensure all power terminals are used. This

cable has to be fused at the battery for safety precautions.

3. The final step is connecting the switched remote.

Keep GROUND of equal lenght. This drawing is for illustration purpose only

We recommend using 12 AWG speaker cables to obtain intended performance. Run

12 AWG speaker cables from your speakers to the amplifier's mounting location.

Keep the speaker cables separate from the power cables and the amplifier's input

cables. Use grommets where the cables have to penetrate the vehicle chassis.

Connect the speaker wires according to the terminals on each speaker.

Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands

together tightly. Make sure there are no strays strands that might touch other cables

or terminals and cause short circuit. Connect the cable ends to the amplifier as

shown in the speaker wiring diagram.