Fox-Lux REM10 사용자 설명서 - 페이지 2
{카테고리_이름} Fox-Lux REM10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fox-Lux REM10 3 페이지. Emergency lighting remote control
Fox-Lux REM10에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
REM10 Remote Control
Functions:
TEST
MT
MT
ON
OFF
AST
AST
ON
OFF
AST
BAT
CHK
CHK
Flashing Codes for Self-test Check (Function 7)
Self-Test Status check
Flashing Code
1x Green/Red
RED/GREEN
LED
Indicator
2x Green/Red
Flashing Code for Battery Health Check (Function 4)
Battery Health/Status Check
Flashing Sequence
GREEN/RED
LED
Indicator
t | +44(0)1543 396400 | e | [email protected] | w | www.fox-lux.co.uk
Functional test 1
Initiate full dur a t i o n t e s t 2
3
Interrupt full d u r a t i o n t e s t
5
Disable se l f - t e s t f u n c t i o n
6
Enable self- t e s t f u n c t i o n
7
Self-test Check
4
Battery Check
Self-test Status
Self-test enabled
Self-test disabled
Battery Status
(emergency lighting duration)
4x Green/Red
Battery not yet tested
(status will be available after first full duration test)
1x Green/Red
duration > 3hr 30min
2x Green/Red
3hr 15min < duration < 3hr 30min
3x Green/Red
3hr < EM duration < 3hr 15min
FUNCTIONS FOR "self-test" VERSIONS:
1. Press "TEST " to carry out a Functional Test
2. Press "MT ON" to initiate a Full Duration Test*
3. Press "MT OFF" to interrupt Full Duration Test
4. Press "BAT CHK" to check status of battery's health.**
5. Press "AST OFF" to disable self-test function
6. Press "AST ON" to enable self-test function
7. Press "AST CHK" to to verify status of self-test function
After each button press the indicator will flash
GREEN/RED
to acknowledge the command
* Note that when the Full Duration Test is completed the
batteries require up to 8 hours to be re-charged again.
** Note that battery status is recorded and updated after full
duration test is completed .
= Off
= On
= Slow flash 0.5Hz
= Normal flash 1Hz (once/second)
= Fast flash 2Hz (twice/second)
Approx. Capacity Reserve
Excess capacity > 16%
Excess capacity < 16% > 8%
Excess capacity < 8% > 0%
-