Daintree GE GEBLXNLG15 설치 매뉴얼 - 페이지 2

{카테고리_이름} Daintree GE GEBLXNLG15에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daintree GE GEBLXNLG15 9 페이지. Light guide forming instructions
Daintree GE GEBLXNLG15에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)

페이지 인쇄

Tetra

Contour Light Guide Forming Instructions

Heating and Forming

For large bends, use either an industrial

oven or heating blanket. For small bends,

use a heat gun.

Bend Type

Planar

Inside Corner

Outside Corner

Option A: Large Bends

Preheat the heating equipment to

300°F (149°C). Heat light guides

approximately 6-15 minutes until

soft and pliable. Bend the light

guide over a printed pattern, routed

template, or use free-forming. A

clean flat insulated surface (wood

or laminated countertop) will help

to prevent twisting or bowing. See

the chart above for minimum bend

radius guidelines.

Allow the light guide to cool by natural convection or lightly forced cool air (i.e. fan). Remove the Bend-Aids for

reuse. In order to remove any minor surface flaws, perform a light sanding using 400 grit sandpaper. Flared or

deformed ends can be trimmed. The light guide is now ready for light engine installation.

NOTE: DO NOT remove the Bend-Aids until the light guide has completely cooled.

NOTE: DO NOT subject heated light guide to freezing or quenching in water.

Minimum Inside

Bend Radius (r)

0.75 in. (19mm)

1 in. (25mm)

1½ in. (38mm)

Option B: Small Bends

Part 1: Move the section back and

forth while rotating about the

diameter until it is soft and pliable.

Gently bend to the desired angle.

It is recommended to use a heat-

deflecting shield to distribute

the heat evenly. Avoid localized

overheating that may result in

distortion or damage (i.e. bubbling)

of the light guide.

CAUTION

Avoid direct contact between hot materials and exposed skin

or combustibles. Use heat resistant gloves while heating and/

or handling any hot materials.

CAUTION

DO NOT use an open flame to heat the light guide.

Heat gun

Part 2: The workable forming time

is about 2–3 minutes. The light

guide must remain in the desired

position until completely cooled. See

the chart above for minimum bend

radius guidelines.

Installation Guide