DS18 BC60LP 소유자 매뉴얼 - 페이지 3

{카테고리_이름} DS18 BC60LP에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DS18 BC60LP 6 페이지.

Step 1: Press MODE selector until LED CHARGING STAGE lights up

Step 2: Press VOL TAGE / BATTERY selector and select the capacity of the batter y to be charged or

the nearest value

Note: If you have more than one batter y, add the capacity of all and then select the nearest value.

Step 3: Connect the Red (+) and Black (-) clamps on the batter y poles;

Step 4: The batter y will be fully charged when the FULL CHARGE led lights up.

Note 1: Phase 1, 2 and 3 LEDs indicate which phase the charging is in.

Note 2: For recovery of exhausted batteries, it is recommended

additional 24 hours after the full charge indication LED is lit. (Phase 3 pulsating charge will be

reactivating the batter y).

Note 3: The charger can be constantly connected to the batter y without any damage to it.

Note 4: If the full charge indication LED does not light up, it means that the batter y cell may be

shorted and impossible to recover.

CHARGING STAGE OPERATION DESCRIPTION:

Charges the batter y in 3 phases (lif t, absorption, equalization). Ideal for recharging / recharging

the batteries when they are low, thus obtaining maximum efficiency without wearing, which

increases the life of the battery.

STEP BY STEP CHARGING STAGE MODE

to leave the power on for an