DS360 MAXX ELECTROSTATIC SPRAYER ULV/MIST SPRAYER 매뉴얼 - 페이지 5

{카테고리_이름} DS360 MAXX ELECTROSTATIC SPRAYER ULV/MIST SPRAYER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DS360 MAXX ELECTROSTATIC SPRAYER ULV/MIST SPRAYER 14 페이지.

페이지 인쇄

The machine consists of a motor/blower assembly, a nozzle system, nozzle

housing, a formulation tank and a metering valve, The various components are

identified in

a diagram below. The blower is a single stage/centrifugal

impeller/axial flow driven by a universal motor operating at a speed of about

20,000 RPM. The blower moves a large amount of air through the nozzle

system consisting of three individual nozzles, each of which has two sets of

directing vanes. One vane set causes the air to be rotated clockwise and the

other causes forces shears the material being dispensed into small particles.

Further, the air rushing by the specially shaped liquid tubes creates a negative

pressure in the liquid tube. This negative pressure causes the liquid to be

drawn from the formulation tank through the control valve and into the nozzle

system where it is pneumatically sheared into aerosol or mist size droplets,

After break-up, the droplets are driven away from the machine by the air

passing through the nozzle system.

Generally, the size of the output droplets increases with increasing

ELECTROSTATIC SWITCH ON-OFF

ULV/MIST

ELECTROSTATIC DROPLETS

ELECTROSTATIC COMPONENT

� AIR

._ LIQUID

WORKING PRINCIPLES

flow rate and with increasing viscosity.

a�

RUBBERGRIP

3 NOZZLES

-:;;:,

METERING

VALVE

FLUID SYSTEMS DIAGRAM

�- MOTOR/BLOWER

f"---....----,

VENTED

/-CAP