Daintree GE Tetra GEPS12-180U-NA 설치 매뉴얼 - 페이지 4

{카테고리_이름} Daintree GE Tetra GEPS12-180U-NA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daintree GE Tetra GEPS12-180U-NA 4 페이지. 120-277 vac input/12 vdc output/180 w

페이지 인쇄

Troubleshooting

Symptom

Solution

All letters are OFF

• Recycle AC power, turn it off, then turn on again.

• If still off, check the power supply DC output voltage using a voltmeter. It should be nominally

Some LEDs appear dim

• Ensure the overall length of the Tetra

• Ensure the length of supply wire is equal to or below the recommended remote mounting distance.

Some of the letters

• Inspect and correct the wires of the non-illuminated letters for damage/polarity issues; If no issues are found, see the

are not illuminated

Shadows

• Re-route supply wire and secure to the back of the can with electrical grade RTV silicone. Adjust wire connector

• Adjust LED layout to ensure uniformity of illumination of the face of the letter.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may

cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at his own expense.

This Class [A] RFLD complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est conforme à la NMB-005 du Canada.

This product is intended to be used as a lamp control gear that is installed after the mains control switch.

For the most up-to-date version of this installation guide, please visit https://products.currentbyge.com/sign-lighting

» If there is DC output, inspect and correct all DC wire damage/polarity issues; If no issue is found, replace the

OFF-module string.

» If there is no DC output, have a licensed electrician check the input AC voltage and if there is correct AC voltage,

replace the power supply.

» If there is no AC voltage, correct the upstream AC issue.

troubleshooting solution for "All letters are OFF."

orientation so that it does not cover any LEDs.

Conforms to the following standards:

GE and the GE Monogram are trademarks of the General Electric Company and are used under license. Information provided is subject to

change without notice. All values are design or typical values when measured under laboratory conditions, and GE makes no warranty or

www.LED.com

SIGN193 (Rev 10/24/19)

LED System does not exceed the maximum load.

GE2022-0007