Daintree GE current WGA100 설치 매뉴얼 - 페이지 7

{카테고리_이름} Daintree GE current WGA100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daintree GE current WGA100 9 페이지. General purpose adapter

Daintree

Networked General Purpose Adapter (WGA100)

Mounting

The WGA100 is designed so that it can be mounted in a

variety of ways.

Using the Mounting Bracket

The mounting bracket included with the WGA100 and shown in

the illustration below provides a screw-mounting alternative. The

bracket has a slot that allows wires to remain connected as you

snap the bracket onto the WGA100 nipple. The WGA100

can be secured at the other end using the integral screw tab.

External to an Enclosure

Alternatively, it can be mounted externally to a junction box

or enclosure through a ½" knockout.

Figure 13: Mounting external to a

junction box or electrical enclosure

Trimming and Dressing

When the wiring connections have been decided and extra

(unused) wires identified, secure the unused wires to keep

them neat, out of the way, and protected against shorting or

interference with other components or devices. It is best

to trim unused low voltage wires to about 5 inches in length,

isolate them using a wire nut or equivalent then bundle

and bind them close to the adapter's body. Be sure that

unused Red and Violet output wires are completely isolated

from all other wires. Unused line voltage wires must be

securely isolated and housed inside a junction box, or

other approved electrical enclosure.

Figure. 12: Mounting with the

included bracket

Installation Guide