Ansel 2012 빠른 시작 매뉴얼

{카테고리_이름} Ansel 2012에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ansel 2012 2 페이지. Client bridge

페이지 인쇄

Wireless Access Point, Client Bridge

Quick Start Guide >>

ANSEL 2012 is a long range outdoor wireless Access Point / Client Bridge that

operates in both 5GHz and 2.4GHz frequency. It provides high bandwidth up to

54Mbps and features dual polarization antenna with high transmitted output

power as well as superior sensitivity. ANSEL 2012 extends radio coverage,

avoids unnecessary roaming between Access Points and ensures a stable

wireless connection while reduces the number of required equipments.

ANSEL 2012 provides user friendly interface including user friendly distance

control ranges from 1KM up to 30KM and RSSI LED indicator oﬀering real time

signal status. It comes with PoE injector for convenient outdoor installation.

ANSEL 2012 enforces transmission security with full support of latest encryption

mechanism including 64/128/152-bit WEP, WPA and WPA2. With 13dBi internal

antenna and superior performance, ANSEL 2012 makes an optimal wireless

solution for both small and large scale projects.

IP Address Configuration

The default IP address of the device is

192.168.1.1. In order to log into this device, you

must first configure the TCP/IP settings of your

PC/Notebook.

In the control panel, double click Network

Connections and then double click on the

connection of your Network Interface

Card (NIC). You will then see the

following screen.

Select Internet Protocol (TCP/IP) and

then click on the Properties button. This

will allow you to configure the TCP/IP

settings of your PC/Notebook.

Select Use the following IP Address radio

button and then enter the IP address

(192.168.1.21) and subnet mask

(255.255.255.0). Ensure that the IP

address and subnet mask are on the

same subnet as the device.

Click on the OK button to close this

window, and once again to close LAN

properties window

Logging In

To configure the device through the web-

browser, enter the IP address of the

Bridge (default: 192.168.1.1) into the

address bar of the web-browser and

press Enter.

After connecting to the IP address, the

web-browser will display the login page.

Specify admin as the default User Name

and Password, and then click on the

Administration

Click on the Administration link under

the Management section. This option

allows you to create a new user name

and password for the device. For security

it is highly recommended for security

reasons.