DAISHIN SBX28L 사용 설명서 - 페이지 6
{카테고리_이름} DAISHIN SBX28L에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAISHIN SBX28L 7 페이지.
페이지 인쇄TROUBLESHOOTING
Malfunctions
0û The engine does not start.
0û The machine is not switched on.
(or is difficult to start.)
0û The fuel tank is empty.
0û No enough priming.
0û The engine sucks excessive fuel.
E
0û Old fuel is being used.
N
0û Do not work at low engine
0û The carburetor was not adjusted
revolution speed. (The engine
properly.
G
stop).
0û It does not accelerate well.
0û Grass coils around the engine.
I
0û The carburetor was not adjusted
properly.
N
0û The idle speed is too low.
E
0û Output power is not sufficient
0û The element (air filter) is dirty.
during operation or the engine
0û Improper fuel is being used.
stops.
0û The cutter does not stop at low
0û The carburetor was not adjusted
B
speed.
properly.
R
0û The clutch spring has trouble.
U
0û The idle speed is too height.
S
H
0û The cutter does not revolve even
0û Grass coils around the cutter.
though revolution speed is
0û The holder or setting plate is loose.
increased.
C
0û Abnormal vibration
0û The cutter is not concentric or a tooth
U
on the edge is chipped.
T
T
0û The drive shaft is bent.
E
0û The bolts on the gear case are loose.
R
BLADE
Pay attention to the following items for safe use of the cutter. [Usable cutter type]
4-cutting edges
8-cutting edges
(star cutter)
(whirl cutter)
0ûUse a blade with an outer diameter of less than 230mm (9 inches).
0ûDo not use a blade with an outer diameter greater than of 250mm (10 inches).
Caution: Never use a chipped or cracked blade! The blade will be damaged and may cause serious injury.
Causes
Remedies
0û Switch the machine on.
0û Refuel the tank.
0û Press the priming pump 5-7 times.
0û Start the engine with the throttle lever
and choke lever fully opened.
0û Exchange it for a new one.
0û Adjust the carburetor.
0û Remove the grass.
0û Adjust the carburetor.
0û Increase the speed until just before the
cutter starts revolving.
(Adjust there carburetor.)
0û Clean the element or replace it.
0û Use proper fuel mix ratio.
0û Adjust the carburetor.
0û Replace the clutch spring.
0û Decrease the speed until the cutter
stops.
0û Remove the grass.
0û Tighten the nuts on the holder or setting
plate.
0û Adjust the hole of the cutter with the
machine and tighten the screws. Or
replace the cutter.
0û Replace the drive shaft.
0û Tighten the bolts on the gear case.
Circular saw edges
Chip saw
(circular saw)
9