DSC PC 2500 사용 설명서 - 페이지 5

{카테고리_이름} DSC PC 2500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC 2500 15 페이지.
DSC PC 2500에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)

MASTER CODE

The 4 digit Master Code is used for arming and disarming the system, for

programming additional access codes, and for changing other features. The

Master Code will be supplied to you by your installer. All keypad entries are

made by pressing one key at a time and may be changed by you at any time if

the installer selects an option. For additional access codes, see Programming

Additional Access Codes.

ARMING

Close all protected doors and windows and stop movement in areas covered by

motion detectors. If the "Bypass" light is ON, be sure zones are being

intentionally bypassed before arming the system (see Zone Bypassing).

Check to see that the "Ready" light is ON (all zones are closed). The system

cannot be armed unless the "Ready" light is ON. Enter a [4 digit access code].

As each digit is entered, the keypad sounder will beep. Once the correct access

code is entered, the "Armed" light will come ON and the keypad sounder will

beep quickly. If the access code was entered incorrectly or the "Ready" light was

not ON, the keypad sounder will beep steadily for 2 seconds.

When the correct access code is entered and the system is armed, exit through

the door indicated by your installer as the exit-entry door. The exit time may be

changed by your installer (please refer to the Quick-Arm feature).

AUTO-BYPASS OPTION - HOME-AWAY ARMING

This feature, if selected by your installer, will allow you to arm your system with

any valid access code and the system will automatically bypass the interior zones

if those interior zones have been designated as home-away zones by the installer.

When activated, the "Bypass" light will come ON. If you exit within the allowed

exit time, the system will automatically reactivate the interior zones. This feature is

designed to save the user from having to manually bypass interior zones each

time they wish to arm the system and remain at home.

In residential applications where the system has been armed and the interior

zones are automatically bypassed, the interior zones can be reactivated from a

keypad outside the interior zones protection area (e.g. a bedroom). To reactivate

the interior zones, press [ ] then [1] and the "Bypass" light will go out.

ENTRY DELAY OFF ARMING

If you wish to arm your system and eliminate the entry delay, enter [ ],[9] before

your access code. The "Armed" light will flash as a reminder that the system is

armed and has no entry delay. An entry through any zone programmed as a

delay zone will create an instant alarm.

e.g. To arm without entry delay.....Press [ ],[9],[Access Code]