DSC PC1550 사용 설명서 - 페이지 5

{카테고리_이름} DSC PC1550에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC1550 17 페이지. 4 digit master code
DSC PC1550에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 사용 설명서 (17 페이지), 사용 설명서 (9 페이지), 사용 설명서 (17 페이지), 사용 설명서 (12 페이지)

페이지 인쇄
DSC PC1550 사용 설명서

Alarm Test

Enter [ ][6][Master Code][8] for a 2-second test of the keypad lights, keypad
buzzer, battery and the bell/siren.
Press [#] to return to Ready.
Programming Security Codes
The Master Code
Enter [ ][5][current Master Code][1][new Master Code]
Press [#] to return to ready
Record your new Master Code on the System Information page in this booklet.
Additional Codes
Up to 5 additional access codes (2 through 6) may be programmed. The
6th access code may be established by your installer as a One-Time use
code.
To program a new code:
Enter [ ][5][Master Code][code number 1 to 6][new 4 digit code]
The [code number] is a single digit either 2, 3, 4, 5 or 6.
Press [#] to return to Ready.
If an access code already exists, it will be replaced by the new code.
Record your new code(s) on the System Information page in this book.
To remove a code:
Enter [ ][5][Master Code][code number][
The [code number] is a single digit either 2, 3, 4, 5 or 6.
Press [#] to return to Ready.
Do not erase the Master Code (code number 1).
NOTE:
It is recommended that the factory default Master Code [1234] not be
used.
One-Time Use Code
The one-time code is designed for entry and exit of the premises for one
occasion only. The panel must be programmed by the installer for this option to
be enabled. The 6th access code is the one-time code.
To use this code, enter your one-time code as the 6th access code using the
previously described commands. When you leave the premises, arm your
system with any access code except the newly entered one-time use code. This
one-time code is given to a person (e.g. a maid) who will enter the premises
while the system is armed and you are away.
The one-time code user enters the premises and disarms the system using the
one-time access code. Upon leaving, the same code is used to arm the system.
As soon as the system is armed, the one-time code is erased and can not be
used to re-enter the premises. A different code can be provided each time for
the one-time user.
]
4