DSC PC2550 사용 설명서 - 페이지 5

{카테고리_이름} DSC PC2550에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC2550 8 페이지.
DSC PC2550에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 사용 설명서 (3 페이지)

페이지 인쇄

1. Programming Additional Access Codes

IMPORTANT

Test system weekly, have

system trouble conditions

corrected by installer.

PRESS [F] for 2 seconds to activate FIRE transmission.

PRESS [A] for 2 seconds to activate an AUXILIARY transmission.

PRESS [P] for 2 seconds to activate PANIC transmission.

THESE BUTTONS WILL NOT FUNCTION UNLESS PROGRAMMED BY INSTALLER.

COLORED LABELS ON KEYPAD DOOR INDICATE WHICH KEYS ARE ACTIVE.

Press [#].....

•

when an error is made in entering code, then enter code again.

•

to return to ready state after using [ ] commands.

Zone Lights, when ON in the normal operating mode, indicate an open zone.

eg. open door, window, etc. Refer to zone chart on keypad door for zone

information.

Fire light is ON when a detector on the fire loop is in alarm. Press any key within

30 seconds of first alarm to get 2 minutes to reset smoke detectors.

Ready light ON: system ready for arming.

Ready light OFF: open zone; must be closed or bypassed before arming.

Ready, Armed and Program lights flashing indicates user code 9-16

programming.

Armed light will come ON indicating system armed. Ensure "Ready" light is ON,

enter [4 digit] access code to arm panel.

Armed, Ready and Program lights flashing indicates user code 9-16

programming.

Memory light ON means an alarm has occurred. To display zone that caused

alarm, press [ ] then [3]. Zone light will come on indicating which zone caused

the alarm.

Bypass light comes ON when you bypass a zone. To bypass a zone, press [ ],

[1], [Access Code] and then the zone(s) you wish to Bypass. Enter 1 for zone

1....8 for zone 8. Press [#] to return to ready.

Trouble light ON means there is a fault on the system. Press any key to silence

keypad beeping. Press [ ] then [2] to display type of trouble.

Zone Light

Trouble

1 ............... Battery

2 ............... A.C. Power

3 ............... Day loop

4 ............... Telephone line

5 ............... Communicator

6 ............... Bell circuit

7 ............... Smoke detector circuit

8 ............... Clock needs resetting

Program light flashes when programming user codes 1 to 8. Press [ ][5], then

enter [Master Code]. Select a code by pressing a key from 1 to 8 and enter the

[4 digit] code. Press [9] to enter codes 9 to 16. "Ready", "Armed" and "Program"

lights will flash. Press [#] to return to ready mode.