DSC PC500RK 사용 설명서 - 페이지 7
{카테고리_이름} DSC PC500RK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC500RK 14 페이지. With pc5oork keypad
DSC PC500RK에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (16 페이지), 사용 설명서 (13 페이지)
PC500RK KEYPAD
The "Ready" light will come ON when the
system is ready to be armed. When the
"Ready" light is OFF, there is an open zone on
the system. The zone must be closed or
bypassed before the system can be armed.
The "Armed" light will come
ON to indicate that the system
is armed. The "Armed" light
will FLASH to indicate that the
system is armed and that there
is no Entry Delay on any of the
zones.
The "System" light will come
ON to indicate:
• that zones are bypassed
• there is a trouble condition
on the system
• there are alarms in
memory.
Use the [ ][1][Access
Code] command to display
the zones that have been
bypassed; be sure that
zones are intentionally
bypassed before arming the
system.
Use the [ ][2] command to
display any trouble
conditions; be sure to have
trouble conditions
corrected by your installer
as soon as possible.
Use the [ ][3] command to
view the alarms in memory.
Important:
Follow the instructions in the manual to test your system weekly. Follow the
guidelines for correcting system trouble conditions; have any system trouble
conditions you cannot correct yourself attended to by your installer.
6
Zone Lights 1 to 4 indicate zone activity. When a
zone is secure, its Zone Light will be OFF; when a
zone is open, its Zone Light will be ON. If a zone
goes into alarm when the system is armed, the
alarm will be indicated on the zone lights until the
system is disarmed.
Press [#]:
• when an error is made in entering an Access Code, then enter
the code again
• to return to "Ready" after using [ ] commands
[F] Key: Press and hold this key for 2 seconds to sound an [F]
Key alarm
[A] Key: Press and hold this key for 2 seconds to generate an
[A] Key alarm
[P] Key: Press and hold this key for 2 seconds to generate a [P]
Key alarm.