DSC PC510 설치 매뉴얼 - 페이지 7
{카테고리_이름} DSC PC510에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC510 20 페이지.
페이지 인쇄KEYPAD FUNCTIONS
Introduction
The Keypad provides complete control of the PC510 security system. The system can be completely
programmed from the keypad. The 4 zone lights provide alarm and status indication for the alarm circuits, and
three function lights advise the user of system status. The built-in sounder lets the user hear correct key entries
and other alert signals. Keypad alarms may be activated by pressing and holding the [F], [A] or [P] Keys. Note
that all keypad entries are made by pressing one key at a time.
Master Code
A default Master Code "1234" is factory programmed into the PC510. The Master Code is used to arm and
disarm the system, to reset the sounder after an alarm, to program additional Access Codes, and to perform
other user functions. The Master Code may be changed by using the [
Codes command.
Installer's Programming Code
A default Installer's Programming Code "0510" is programmed into the PC510. Using this code and the [
command, the installer can perform programming functions. This code should be changed by the installer after
the system is installed; refer to Programming Section [3].
Arming
Before arming the system, close all protected doors and windows and stop movement in areas covered by
motion detectors. If the "System" light is on, check for trouble conditions (refer to [
and correct the condition. Ensure that any bypassed zones are bypassed intentionally; refer to [
Code]: Bypass Zones. If the "Ready" light is not on, one or more zones are open; the system can only be
armed when the "Ready" light is ON.
To arm the system, enter a 4-digit Access Code. As each digit is entered, the keypad sounder will beep. When
the Access Code has been entered, the "Armed" light will come ON and the keypad will beep 6 times. If the
Access Code has been entered incorrectly, the keypad will sound a single long tone; press the [#] Key and enter
the Access Code again.
When an Access Code has been entered and the "Armed" light is ON, leave the premises through the
designated Entry-Exit door before the Exit Delay expires. At the end of the Exit Delay, all lights on the keypad
will be shut OFF except for the "Armed" light.
The default setting for the Exit Delay is 120 seconds. Refer to Programming Section [1] Zone Definitions for
information on zone types that are affected by the Exit Delay. Also refer to Programming Section [2] for
instructions on changing the Exit Delay.
Auto-Bypass/Home-Away Arming
If an Access Code is entered and the Exit-Entry zone is not activated, the system will arm with interior zones
automatically bypassed if those zones have been programmed as Home-Away Zones.
This feature is designed for the user who wishes to remain at home with the system armed. When this feature
is enabled, the user does not have to manually bypass zones programmed as Home-Away zones.
At-Home Arming
To eliminate the Entry Delay, arm the system by entering [
may then be made as in normal arming. The system will arm as described above in Auto-Bypass/Home-Away
arming whether an exit is made or not. The "Armed" light will FLASH to indicate that the system is armed and
that there is no entry delay on any of the Delay Zones. If any zone other than a Home-Away zone is activated,
an alarm will sound immediately.
firealarmresources.com
∗
][5][Master Code] Program Access
∗
][9][Access Code]; an exit through a Delay Zone
∗
][8]
∗
][2]: Display Troubles)
∗
][1][Access
5