DSC PC51O2-433NA 설치 매뉴얼 - 페이지 2

{카테고리_이름} DSC PC51O2-433NA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC51O2-433NA 13 페이지.

페이지 인쇄

1.4

Batteries

The PWLS909-433/WLS909-433 use three A-76 batteries and the PWLS919-433/WLS919-

433 use two CR2032 lithium batteries.

Section 2: PC5102-433 Set Up & Wiring

This section describes how to set up and wire the PC5102-433 module.

2.1

Choose a Mounting Location for the PC5102-433

NOTE

NOTE: Mount the PC5102-433 receiver and wireless keys after you have done place-

NOTE

ment tests with the wireless keys (see sections 5.1 and 5.2).

Find a place that is (1) dry (2) close to the point of entry (3) high as possible and (4) far

from sources of interference, including: electrical noise (computers, televisions and

electric motors in appliances and heating and air conditioning units); large metal objects

like heating ducts and plumbing which may shield the antenna.

NOTE: Make sure that electrical wires will not run over the antenna of the module when it

is mounted.

When mounting the PC5102-433 in a basement, place the module as high and as close

to the underside of the first floor as possible. The range of the module will be reduced if

the unit is mounted below ground level.

2.2

Terminal Descriptions

The PC5102-433 has 2 on-board relay outputs which can be used in many different

applications. They can be used to activate LEDs, open garage doors, trigger X-10 devices etc.

NO1

NC1 COM1 NO2

NC2 COM2 RED

NO1- PGM1 Normally Open Relay Contact

NC1- PGM1 Normally Closed Relay Contact

COM1- PGM1 Relay Common Contact

NO2- PGM2 Normally Open Relay Contact

NC2- PGM2 Normally Closed Relay Contact

COM2- PGM2 Relay Common Contact

2.3

Connecting the PC5102-433 Receiver

CAUTION: Remove all power from the system while connecting modules to the Keybus .

Control Panel

RED BLK YEL GRN

NOTE: Each control panel may either have a PC5102 or a PC5132 enrolled but not both.

2.4 Connecting the LED to the PC5102-433

The LED can be used to indicate whether the

system is armed or disarmed. If the output is

programmed as an armed status output, the red

LED will turn on when the system is armed and

will turn off when the system is disarmed.

BLK

YEL GRN

Connect the PC5102-433 to the four-wire Keybus of

the control panel according to the following dia-

gram.

After you have completed the wiring, reconnect the

power to the security system. Now that you have

wired the PC5102-433, you should enroll and pro-

KEYBUS TO

gram the wireless keys. See Section 3 for instruc-

PC5102

tions.

firealarmresources.com

RED- Keybus Power +12V

BLK- Keybus Ground

YEL- Keybus Clock

GRN- Keybus Data

ANT1

COM1

NO2

NO1

NC1

RED

BLACK

NC2

COM2

RED

BLK

YEL

GRN