ANSI PALOMA 사용자 지침 - 페이지 10

{카테고리_이름} ANSI PALOMA에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ANSI PALOMA 16 페이지. Full body harness

6. Donning

Sewn terminations should be secure, complete, and not visibly damaged. No load indicators shall be deployed.

Note:

Damaged and other deteriorated and defective components must be immediately removed from service.

Fitting an Full Body Harness

Follow step from 1 to 7 for wearing harness:

Step 1: Hold the harness by the dorsal D-ring and shake to allow any tangled straps to fall into place.

Step 2: Unbuckle chest and leg straps. If the harness has waist belt, unbuckle it too.

Step 3: Slip the straps over the shoulders, so the back D-ring is located in the middle of the back between shoulder blades.

Step 4: Connect the chest strap and position in the mid chest area, then adjust shoulder straps with the two adjusters

located at the lower end of the shoulder strap. Adjust the left and right sides to the same length.

Step 5: Pull the end of one leg strap between the legs and secure to the opposite end. Repeat this step with the other leg.

If harness has waist belt, connect that after the leg straps.

Step 6: After all the buckles have been connected, adjust so that the harness fits snug, but allows full range of movement.

Step 7: Use the back D-ring or the front anchor point joined together by a connector as anchor point for fall arrest systems.

To locate the anchor points on the harness, check for the "A" marking near them.

Rev.C1 of 210602