DAITEM SH601AU 설치 매뉴얼 - 페이지 16

{카테고리_이름} DAITEM SH601AU에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAITEM SH601AU 20 페이지. Alarm pendant

페이지 인쇄

8. Performing a real test

IMPORTANT

• You are now going to perform a real test in user mode. Depending on the command sent by the sliding part or the

push-button, this test may trigger the alarm devices and telephone transmission.

• We advise you to warn your correspondents beforehand, as well as neighbours, and not to let the sirens sound for

too long. The siren's sounding power can cause hearing disorders and the necessary precautions must therefore be

taken.

1. Switch the control panel (or

dialler) to user mode (see

previous section).

2. A. Pull down on the sliding

part. The pendant LED

ﬂashes for roughly 2 s and

then goes out.

- Close the sliding part.

- Using the table

opposite, check that the

system responds to the

command sent.

B. Press the push-button for

several seconds and

check the system

responds.

Command

Control panel

description

Alarm

sounding: 90 s (1)

Silent alarm

no sounding (1)

(factory setting)

Local call

"beep, beep, beep, no response

beep, Emergency

call.." 3 min

Fire alarm (2)

fire sounding:

5 min

Door bell (2)

ding dong

Audible signal (2)

"beep, beep, beep, no response

beep"

(1) For control panels with a relay, the control panel relay is triggered for 90 s.

(2) "Comfort" type command (green). Only possible with the push-button (see chapter on

"Advanced programming").

System responses in user mode

Outdoor siren

Dialler

sounding: 90 s

transmission:

alarm

no response

transmission:

alarm

no response

fire sounding:

transmission:

5 min

fire alarm,

command n°

no response

Control

panel alarm panel

memory

events log

yes