DAITEM SH601AU 설치 매뉴얼 - 페이지 5

{카테고리_이름} DAITEM SH601AU에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAITEM SH601AU 20 페이지. Alarm pendant

2. Operation

Sliding part

Quick-

fastener

• The pendant can be activated by pulling

the sliding part down or by pressing on

the push-button (for more than 2 sec.). If

the sliding part stays in downward

position, the message is transmitted every

15 min.

• The pendant is factory-conﬁgured to send

the "Silent alarm" command. The sliding

part and push-button can be

programmed separately to send the

"Alarm" or "Local call" command

(see chapter on "Main conﬁguration

operations").

• The push-button can also be reprogrammed to send "Comfort"

Push-button

and LED

• The push-button LED shows that the pendant is working

type commands (see chapter on "Advanced programming") in

order to:

- trigger a ﬁre alarm,

- activate beeping or the door bell function on the control panel,

- operate an electrical device or lighting via external receivers or

remote-controlled sockets.

properly:

- it indicates the battery status when the button is brieﬂy pressed,

- it conﬁrms the different radio commands transmitted by the

sliding part or the push-button:

* "Call" type ("Alarm", "Silent alarm" or "Local call"): the LED

ﬂashes red,

* "Comfort" type: the LED ﬂashes green (push-button only).

Each command sent by pressing the push-button for longer

than 2 seconds (LED ﬂashes green or red), is preceded by a

"battery status test" indicated by the LED brieﬂy ﬂashing red.

- it conﬁrms conﬁguration and indicates the function allocated to

the sliding part or push-button (in programming mode).