DSC PowerSeries PC1616 설치 매뉴얼 - 페이지 15

{카테고리_이름} DSC PowerSeries PC1616에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries PC1616 20 페이지. System enhancement module
DSC PowerSeries PC1616에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 빠른 매뉴얼 (4 페이지), 매뉴얼 (18 페이지)

페이지 인쇄

LED L5 (YELLOW)

L5 indicates Z-Wave errors. If you can't add a device to the network, try

deleting the device and re-adding it to the network. Contact Alarm.com

Technical Support with additional issues.

ALARM.COM MODULE STATES (MODES)

There are three Alarm.com module states (modes).

Idle Mode

In Idle mode, the AC power is up, the battery level is greater than 11.5

volts, and the SEM is not currently connected to the Alarm.com servers.

This is normal for the SEM and is the most common state.

Flashes errors, if any

Communication with panel

Communication with radio unit

Signal level (0 to 5 bars)

Flashes errors, if any

PowerSave Mode

In PowerSave mode, the module just powered up, AC power is down, or

battery level is less than 11.5 volts. The radio part of the SEM draws 10 mA

in PowerSave mode. It is fully functional and will go into Connected mode

as soon as a signal needs to be sent. Performing an Alarm.coml phone test

will switch the module into Idle mode and update the signal level reading.

Inactive

Communication with panel

Same flashing pattern as L2

Inactive

Connected Mode

In Connected mode, the SEM is connected to the Alarm.com servers and

reported an alarm or other condition. The module stays in Connected mode

for at least six minutes after the last message is exchanged. Entering

Installer programming will cause the SEM to go into Idle mode.

Flashes errors, if any

Communication with panel

Communication with Alarm.com

Alternates two seconds on, then two seconds off

Inactive