DSC PowerSeries PC1864 설치 매뉴얼 - 페이지 11
{카테고리_이름} DSC PowerSeries PC1864에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries PC1864 20 페이지. System
enhancement
module
DSC PowerSeries PC1864에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 매뉴얼 (18 페이지)
페이지 인쇄
Using the Dealer Website
1.
Move all Z-Wave devices to their final location on the property.
2.
Navigate to the Equipment page on the Dealer Website.
3.
Click the emPower Devices tab.
4.
Open the Advanced Z-Wave Commands menu below
the Equipment List.
5.
Click Add Z-Wave Devices.
Wait for the bolded message: Checking for new devices
6.
on the network.
7.
Trigger a device to add it to the network.
8.
When a device is added successfully, it will show up
on this screen following a 30 second delay.
9.
Continue triggering devices. You may add several devices
to the network without re-entering Add Mode.
Using the SEM
1.
Press and hold Z-Wave button on the Alarm.com module.
2.
Release the button once LED L2 flashes in groups of four.
3.
Trigger a device to add it to the network.
4.
When a device is added successfully, L2 will illuminate solid.
5.
You will need to re-enter Add Mode before triggering the
next device.
If you can't add a device to the network, you may need to
TIP:
delete the device's current network data using the device
deletion process before you can add it to the new network
(some devices come from the factory with network data).
11