DSC PowerSeries PC1864 매뉴얼 - 페이지 10

{카테고리_이름} DSC PowerSeries PC1864에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries PC1864 18 페이지. System enhancement module
DSC PowerSeries PC1864에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (20 페이지)

DSC PowerSeries PC1864 매뉴얼
DSC Power Series PC1616 PC1832 PC1864 System Manual
Note: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other codes.
This feature cannot prevent the Arm/Disarming squawks from being generated if an access code
assigned to a WLS Key is manually entered at a keypad.

Partition Assignment Mask

In order to accommodate Access Code Partition Assignment for the multiple partitions found on this
product the user must enter [*][5][Master Code][8][Code number to be change] (ex. [*][5][1234][8][Code
03]. Under this section, each bit represents the corresponding partition's access (i.e. Bit 4 represents
Partition 4 access).
The Master Code has access to all partitions, and cannot be modified.
Partition Assignment Mask ([*][5][Master/Supervisor Code][8][Code])
1. Partition One Access
2. Partition Two Access
3. Partition Three Access
4. Partition Four Access
5. Partition Five Access
6. Partition Six Access
7. Partition Seven Access
8. Partition Eight Access
Notes on Access Codes and Programming
1. There will still be 37 codes if option selected for 6-digit access codes.
[*][5][MASTER CODE] [01 to 32, 33, 34, 40, 41, 42] to program access codes
[*][5][MASTER CODE][8] enters the Partition Assignment Mode [01 to 32, 33, 34, 41, 42] to
edit access code partition assignments
[*][5][MASTER CODE][9] Enters the Attribute Mode [01 to 32, 33, 34, 41, 42] to edit access
code Attributes
2. The Master Code's attributes cannot be changed.
3. When a new code is programmed in [*][5] it will be checked against all other codes in the system. If
a duplicate code is found, an error tone is given and the code is returned to what it was before it
was changed. This applies to both 4 and 6-digit codes.
Erasing an Access Code
To erase a code, select the code and enter [*] as the first digit. If [*] is entered, the system will delete the
code immediately and the user will be returned to select another code.
https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]