DSC PowerSeries PK5501 사용 설명서 - 페이지 3

{카테고리_이름} DSC PowerSeries PK5501에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries PK5501 20 페이지. Power pk55xx/rfk55xx-433 series
DSC PowerSeries PK5501에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (9 페이지)

페이지 인쇄

About Your Security System

Your DSC Security System has been designed to provide you with the greatest possible flexibility and

convenience. Read this manual carefully and have your installer instruct you on your system's opera-

tion and on which features have been implemented in your system. All users of this system should be

equally instructed in its use. Fill out the "System Information" page with all of your zone information

and access codes and store this manual in a safe place for future reference.

Fire Detection

This equipment is capable of monitoring fire detection devices such as smoke detectors and provid-

ing a warning if a fire condition is detected. Good fire detection depends on having adequate num-

ber of detectors placed in appropriate locations. This equipment should be installed in accordance

with NFPA 72 (N.F.P.A., Batterymarch Park, Quincey MA 02269). Carefully review the Family Escape

Planning guidelines in this manual.

NOTE: Your installer must enable the fire detection portion of this equipment before it becomes

functional.

Testing

To insure that your system continues to function as intended, you must test your system weekly.

Please refer to the "Testing your System" section in this manual. If your system does not function

properly, call your installing company for service.

Monitoring

This system is capable of transmitting alarms, troubles & emergency information to a central station. If you

initiate an alarm by mistake, immediately call the central station to prevent an unnecessary response.

NOTE: The monitoring function must be enabled by the installer before it becomes functional.

Maintenance

With normal use, the system requires minimum maintenance. Note the following points:

• Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened cloth

should remove normal accumulations of dust.

• Use the system test described in "Testing Your System" to check the battery condition. We recom-

mend, however, that the standby batteries be replaced every 3-5 years.

• For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion

detectors or glassbreak detectors, consult the manufacturer's literature for testing and maintenance

instructions.

General System Operation

Your security system is made up of a DSC control panel, one or more keypads and various sensors

and detectors. The control panel will be mounted out of the way in a utility closet or in a basement.

The metal cabinet contains the system electronics, fuses and standby battery.

NOTE: Only the installer or service professional should have access to the control panel.

All the keypads have an audible indicator and command entry keys. The LED keypads have a group

of zone and system status lights. The LCD keypad has an alphanumeric liquid crystal display (LCD).

The keypad is used to send commands to the system and to display the current system status. The

keypad(s) will be mounted in a convenient location inside the protected premises close to the entry/

exit door(s).

The security system has several zones of area protection and each of these zones will be connected

to one or more sensors (motion detectors, glassbreak detectors, door contacts, etc.). A sensor in

alarm will be indicated by the corresponding zone lights flashing on a LED keypad or by written mes-

sages on the LCD keypad.