DSC PowerSeries SCW9047-433 사용자 설명서 - 페이지 15

{카테고리_이름} DSC PowerSeries SCW9047-433에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries SCW9047-433 20 페이지. Self contained wireless
DSC PowerSeries SCW9047-433에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

Testing Your System

NOTE: Inform your Monitoring Station when you begin and end System Testing.

All smoke detectors in this installation must be tested by your smoke detector installer or dealer once

a year to ensure they are functioning correctly. It is the user's responsibility to test the system weekly

(excluding smoke detectors). Ensure you follow all the steps in the two tests below.

NOTE: Should the system fail to function properly, call your installation company for service im-

mediately.

Sounder and Display Test

This Test activates all display pixels and indicator lights and does a two-second check of the sounder.

1. Press

[Master Code]

2. The following will occur:

- The system activates the Bell output on medium volume for 2 seconds. All display lights and LCD

pixels will turn ON.

- The Ready, Armed, Trouble and Power LED's will flash for the duration of the test

3. To exit the function menu, press

Walk Test

Walk Test mode allows you test the operation of each detector in the system. While in Walk Test

mode, the Ready, Armed, and Trouble LED's will flash to indicate that the Walk Test is active. The

Walk Test can be terminated at anytime by re-entering

system will also automatically terminate the Walk Test on completion, it will annunciate with an audi-

ble warning (5 beeps every 10 seconds), beginning five minutes before the termination of the test.

1. Before testing, ensure that the system is disarmed and the Ready light is on.

2. Press

and close all zones to return the system to the Ready state.

3. Perform a System Test by following the steps in the previous section.

4. Press

[Master code]

5. To test the zones, activate each detector in turn (e.g., open each door/window or walk in motion

detector areas).

The System will display the following message when each zone (detector) is activated: "Secure

System Before Arming < >", "Secure System or Enter Code" or "Secure or Arm System". Use the

keys to view which zones are open. The message will disappear when the zones are

closed.

Allowing Computer Access To Your System

From time to time, your installer may need to send information to or retrieve information from your

security system. Your installer will do this by having a computer call your system over the telephone

line. You may need to prepare your system to receive this 'downloading' call. To do this:

Press

[Master code]

time. During this time, the system will answer incoming downloading calls.

For more information on this feature, please ask your installer.

to initiate the Walk Test

at the keypad. This allows downloading for a limited period of

[Master code]

on the keypad.The