DSC SCW9047-868 사용자 설명서 - 페이지 11

{카테고리_이름} DSC SCW9047-868에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC SCW9047-868 20 페이지. Self contained wireless
DSC SCW9047-868에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

Access Codes

[ ][5][Master Code] (when disarmed)

The [ ][5] User's Programming command is used to program additional access codes.

User Codes - User Codes 1-16 are available for the System.

Master Code (Access Code 40)

mable Attributes list below.

Supervisor Codes

ming section. However, these codes can only program additional codes which have equal or lesser

attributes. Once programmed, the Supervisor Codes receive the Master Code's attributes. These

attributes are changeable. Any User Code can be made a supervisor code by enabling User Code

Attribute 1 (please see below for details).

Duress Codes

- Duress codes are standard User Codes that will transmit the Duress Reporting Code

whenever the code is entered to perform any function on the system. Any User Code can be made a

Duress Code by enabling User Code Attribute 2 (please see below for details).

One Time Use Code - This code permits temporary access to the system for a 24 Hr. time

period. During the 24 Hr. period, the temporary user may disarm the system once. There is no

restriction on the number of times the temporary user may arm the system during the time

period.

NOTE: Duress codes are not valid when entering [ ][5], [ ][6] or [ ][8] sections.

NOTE: Access codes cannot be programmed as a duplicate or as a "Code +/- 1".

User Code Attributes

1. The default attributes of a new code will be the attributes of the code used to enter

whether it is a new code or an existing code being programmed.

2. System Master (Code 40) has Attribute 3 ON by default.

NOTE: These attributes are not changeable.

Inherent Attributes (all codes except installer)

Arm / Disarm

- Any Access Code will be valid for arming and disarming the system.

Command Outputs ([ ][7][1] and [ ][7][2])

Access Code is valid for performing the [ ][7][1-2][Access Code] functions on the system.

Programmable Attributes ([ ][5][Master/Supervisor Code][9][Code])

Supervisor Code

Duress Code

Zone Bypassing Enabled

4-6 For Future Use

Bell Squawk upon Arming/Disarming

One Time Use Code

Zone Bypassing Attribute

This attribute allows the User to manually bypass zones if Bypassing requires an access code.

Bell Squawk Attribute

This attribute is used to determine whether an access code should generate an arming/disarming Bell

Squawk upon entry of the code for Away arming. The Wireless Keys with access codes associated

with them may generate Arming/Disarming Bell squawks. If desired, this option may be used with

codes that are manually entered. Please contact your installer to have this programmed.

NOTE: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other

codes.

NOTE: This feature cannot prevent the Arm/Disarming squawks from being generated if an access

code assigned to a WLS Key is manually entered at a keypad.

Erasing an Access Code

To erase a code, select the code and enter

delete the code immediately and the user will be returned to select another code.

- The Master Code has all of the attributes listed in the Program-

- These codes are always valid when entering the

- If these outputs require Access Code entry, any

as the first digit. If

User Code Program-

is entered, the system will