DSC PC1150 사용 설명서 - 페이지 9
{카테고리_이름} DSC PC1150에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC1150 13 페이지. Tyco security system instruction manual
페이지 인쇄PC1150 Keypad
The Zone Lights will come ON when the system is disarmed
to indicate that there is activity in a zone. Refer to the System
Information page at the front of this manual for zone information.
DOC LN/MDC IC 2
Press [1]+[3] for 2 seconds to activate a Pulsed alarm
Press [4]+[6] for 2 seconds to activate an Auxiliary alarm
Press [ ]+[#] for 2 seconds to activate a Panic alarm
The Keypad Zones will not function unless they are enabled
Trouble Conditions: The "System" light will come ON when there is a fault on
the system. Press any key to silence the keypad sounder. Press [ ] then [2]
to display the trouble condition. Call for service if you are unable to correct a
trouble condition.
Light
Zone 1
Zone 2
Zone 3
Zone 4
"Ready"
"Bypass"
Zone 1
Zone 2
Zone 3
Zone 4
1
4
7
PC1 15O
Keypad Zones:
by your Installer.
Trouble Type
Low battery
AC failure (keypad
buzzer will not sound)
System Fuse open
Fail to communicate
Not used to indicate troubles
Clock needs resetting
The "Ready" light will come ON to indicate
that the system is ready to be armed.
When the "Ready" light is OFF, there is an
open zone on the system. All zones must
be either secure or bypassed before the
Ready
system may be armed.
Armed
System
The "Armed" light will come ON to
indicate that the system is armed. To
2
3
arm the system, first ensure that the
"Ready" light is ON, then enter an
5
6
Access Code.
9
8
The "System" light is used to indicate a
0
#
number of conditions on the system that
ACCESS
may require attention before the system is
armed. When the "System" light is ON,
check the following:
Refer to this instruction manual for
complete instructions on using these
features.
Press [#]...
What to do
Call for service
Check fusebox for
open fuses; call for service
Call for service
Call for service
Reset the system time
• press [ ][1][9] to view Bypassed
Zones
• press [ ][2] to view Trouble
Conditions
• press [ ][3] to view the Alarm Memory
Display
• when an error is made in entering
code, then enter code again.
• to return to ready state after using
[ ] commands.
7