FOXeye GC1 MOTO CAM 사용자 설명서
{카테고리_이름} FOXeye GC1 MOTO CAM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FOXeye GC1 MOTO CAM 2 페이지.
페이지 인쇄1
Main Device
Fasten Points
Adjustable Lens
Micro USB
Installation Diagram
1. Place the 3M VHB tape onto the Metallic mount.
2. Stick the silica gel patches between the mount and the joints, then screw in the screws.
3. Stick the silica gel patches between the main device and the joints, then screw in the screws.
4. Make sure to clean the surface of where you want to install the mount to, and rip off the other side of the 3M tape and
stick it to the said surface, and press for at least 5 seconds when applying the mount.
5. Adjust the main device and the joint to desired positions, then screw down the screws tight.
6. If the surface you are installing to is curved, please bend the mount to fit the surface.
Metallic Joint x 2 pcs
2
Power Box
3
Control Panel
Record Button
Wi-Fi Button
Port (P.9)
3M VHB Tape
Main Device
MOTO CAM User Manual
Motorcycle
Ignition Switch
Motorcycle
Battery
GC1
USB Port
(P.8)
Record Light
Wi-Fi Light
Power Light
Power Button
Wiring Diagram
Power+
Headlight or
RELAY
Indicator Switch
Motorcycle Power Ground or Battery Ground
3
1
2
Metallic Mount
Silica Gel Patches x 4 pcs
Fine Thread
Hex Head Screw x 2 pcs
Coarse Thread
Hex Head Screw x 2 pcs
Power+
Power Box
Power-
Headlight or
Indicator
GC1