DSC WS4945 빠른 시작 매뉴얼

{카테고리_이름} DSC WS4945에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC WS4945 2 페이지. Wireless door/window contact

WS4945

Wireless Door/Window Contact

This Installation Manual shall be used in conjunction with the Installation Manual of the DSC wireless

receiver and control panel with which this device is intended to be used.

Powering the WS4945

For your added convenience, the WS4945 comes with the battery pre-installed. To activate, hold the WS4945

firmly in one hand and pull the plastic tab in the direction indicated.

Locate Transmitter

Select the location where the WS4945 is to be mounted.

NOTE: RF signals can be affected by metal objects, including

metal doors or large mirrors.

Such locations should be avoided, they can interfere with proper operation.

Enrolling, Programming and Placement

Enroll the WS4945 by programming the 6-digit serial number (located on the WS4945) into the receiver. Once

the WS4945 is enrolled, you must perform a Module Placement test to ensure the location you have chosen is

suitable. The following outlines the basic steps for programming and enrolling this device on PowerSeries receiv-

ers. For additional options or for other receivers please refer to the specific receiver installation manuals.

Step 1 – Program Electronic Serial Number (ESN)

Section [804], subsections [01] – [32]

[01] Zone 1 ... [32] Zone 32

Enter the 6 digit ESN located on the WS4945 into the next available zone slot.

Step 2 – Program Zone Definition

Section [001] – [004]

Define corresponding zone with appropriate zone type [Ex. Delay (01), Instant (03), etc.]

Step 3 – Enable Wireless Zone Attribute

Section [101] – [132]

Turn Option [8] ON (wireless zone attribute) in corresponding zone attribute section.

NOTE: All wireless devices must be tested for good signal strength from where they are positioned.

Step 4 – Device Placement Test

Section [904], subsections [01] – [32]

Open and close the contact by moving the magnet away from the WS4945. The panel will

indicate the test result through the siren (and also through the keypad):

1 bell squawk/beep on LCD keypad/LED 1 on LED keypad) indicates GOOD placement

3 bell squawks/beeps on LCD keypad/LED 3 on LED keypad) indicates BAD placement

If the transmitter tests BAD, move the transmitter and repeat the Placement Test.

NOTE: Test unit at least once yearly. UL listed for residential applications.

Mounting the WS4945 and Magnet

Once you determine the proper location (see Enrolling, Programming and Placement), the WS4945 can be per-

manently mounted. NOTE: It is the responsibility of the installer to ensure that the WS4945 is securely

mounted in the intended location.

Using Provided Screws: Remove the back from the transmitter. Mount the back housing of the WS4945, using

the screws supplied, to the desired location.

Using Adhesive Tape: