FOXFURY 940K-010PIC 제품 설명서 - 페이지 3

{카테고리_이름} FOXFURY 940K-010PIC에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FOXFURY 940K-010PIC 7 페이지. Sideslide series

페이지 인쇄

BATTERIES

The SideSlide Series flashlight requires one (1) 18650 battery or two (2)

CR123 batteries.

Mixing of new and used, or different brand batteries is not recommended

as this could lead to leakage or explosion.

BATTERY INSTALLATION AND REPLACEMENT

Twist the Tailcap in a counter-clockwise direction to remove it.

Insert the battery with the positive end first. (Respect appropriate polarity

when installing).

Re-install the Tailcap by twisting it in a clockwise direction back onto the

Handle. (Make sure the Tailcap is tightly sealed).

Test the light's performance and function by activating the Power/Mode

Switch (located at the end of the Tailcap).

BATTERY LIFE

MODE

940K-010FI & 940K-010RSC

HIGH POWER

LOW POWER

BLINKER

TURBO-STROBE

™

*Battery life may vary according to mode selected, battery quality and prevailing ambient conditions.

TAILCAP

–

BATTERY

940K-010PIC

4 hrs

90 minutes

10 hrs

8 hrs

—

4 hrs

OPERATIONAL MODES

FOR THE C-CLAMP AND BOL T MOUNTS:

For HIGH mode: Press the Power/Mode Switch once.

For LOW mode: Press and hold the Power/Mode Switch for 2.0–2.5 sec.

For BLINKER mode: While in LOW mode, press and hold the Power/Mode

Switch for an additional 2.0–2.5 sec.

FOR THE PICATINNY MOUNT:

For MOMENTARY mode: Press and hold the Power/Mode Switch. While

the Switch is depressed, the flashlight will operate in HIGH mode. When

the user removes pressure from the Switch, the light will turn OFF .

For HIGH mode: Press the Power/Mode Switch two (2) times in rapid

succession. The light will remain in HIGH mode.

For LOW mode: While in HIGH mode, press and hold the Power/Mode

Switch for two (2) seconds. The mode will change to a LOW setting.

For TURBO-STROBE

: Press the Power/Mode Switch three (3) times in

™

rapid succession.

For OFF or EXIT a mode: Press the Power/Mode Switch once. Then,

continue following the directions above to progress to desired mode.

NOTE:

The light does not retain the mode in memory . Once you turn the

flashlight ON, you will have to re-select the mode you desire.

When the light is ON in any mode, a rear green warning light will flash

(excluding Picatinny model).

NOTES