DSC LCD5501Z 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} DSC LCD5501Z에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC LCD5501Z 12 페이지. Dsc keypad
DSC LCD5501Z에 대해서도 마찬가지입니다: 사용 (4 페이지)

페이지 인쇄

Wiring

1. Before beginning to wire the unit, ensure that

all power (AC transformer and battery) is

disconnected from the control panel.

2. Connect the four Keybus wires from the control

panel (red, black, yellow and green) to the

keypad terminals (R B Y G). Consult the diagram

below:

3. You can connect a device - such as a door

contact - to the "Z" terminal of the LCD5501Z.

This eliminates the need to run wires back to

the control panel for the device. To connect the

zone, run one wire from the device to the Z

terminal and the other wire from the device to

the B (black) terminal. For powered devices,

run the red wire to the R (positive) terminal and

the black wire to the B (negative) terminal. When

using end of line supervision, connect the zone

according to one of the configurations outlined

in your system's Installation Manual .

Applying Power

Once all wiring is complete, apply power to the

control panel:

1. Connect the battery leads to the battery.

2. Connect the AC transformer.

For more information on control panel power

specifications, see the control panel Installation

Manual .

NOTE: Do not connect the power until all wiring is

complete.

Enrolling the Keypad

Once all wiring is complete, you will need to

enter a 2-digit number that tells the system the

partition and slot assignment of the keypad.

If your system has partitions, you will need to

also assign the keypad to a partition (1st digit).

The slot assignment (2nd digit) tells the panel

which keypad slots are occupied. The panel

can then generate a fault when a keypad

supervisory signal is not present. There are

eight available slots for keypads. LCD5501Z

keypads are always assigned to slot 1 by

default. You will need to assign each keypad

to its own slot (1 to 8).

Enter the following at each keypad installed on

the system:

1. Enter Installer Programming by pressing

[*][8][Installer's Code]

2. Press [000] for Keypad Programming

3. Press [0] for Partition and Slot Assignment

4. Enter a two digit number to specify the

partition and slot assignment.

NOTE: If your system does not have partitions,

enter [1] for the first digit.

1st digit

Enter 0 for Global Keypad

Enter 1 for Partition 1 Keypad

Enter 2 for Partition 2 Keypad

Enter 3 for Partition 3 Keypad

Enter 4 for Partition 4 Keypad

Enter 5 for Partition 5 Keypad

Enter 6 for Partition 6 Keypad

Enter 7 for Partition 7 Keypad

Enter 8 for Partition 8 Keypad

2nd digit

Enter 1 to 8 for Slot Assignment

5. Press the [#] key twice to exit programming.

6. After assigning all keypads, perform a

supervisory reset by entering [*][8][Installer's

Code][902]. The panel will now supervise all

assigned keypads and enrolled modules on

the system.