Foxfury Lighting Solutions 200-9T32 제품 설명서 - 페이지 16

{카테고리_이름} Foxfury Lighting Solutions 200-9T32에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Foxfury Lighting Solutions 200-9T32 20 페이지.
Foxfury Lighting Solutions 200-9T32에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

Foxfury Lighting Solutions 200-9T32 제품 설명서

GENERAL MAINTENANCE TIPS

The Nomad

may depend on ambient conditions and battery health).

Maintain the light fully charged at all times, so that it is ready for use in

the event of an emergency .

If used outdoors in cold weather for an extended period of time allow the

Nomad

Lithium-Ion batteries have a 500 full charge cycle life (CC followed by a

CV cycle)*. When the light gets near this number of cycles, there will be a

decrease in usage time. *CC=Constant Current charge (fast rate)

The lithium-Ion batteries have a top-off or micro-charge life of around

1,200 cycles or more (CV only)*. If the Nomad

days, plug in the AC-DC Adaptor for 1 to 2 hours to bring the batteries

back up to peak charge. *CV=Constant Voltage charge (slow rate)

As needed, wash the Nomad

and a mild soap. When done, pat dry with a soft cloth.

STORING YOUR NOMAD

Make sure the light is powered OFF by pressing the Power/Mode Switch

until the light is no longer ON.

Be sure to CLOSE the Light Panels back into the 360 configuration

BEFORE lowering the Tripo-Scope

Put the Nomad

Tripo-Scope

Then, push the Light Head back into the Locking Sleeve.

If the AC-DC Adaptor or 12VDC Vehicle Adaptor is being used,

disconnect it from the Nomad

WARNINGS WHEN STORING

The Nomad

being ON for a while, the Nomad

heat) behind the Light Head will become warm to the touch (possibly hot)

depending upon the run time, setting, and/or air temperature. The warmer

the ambient air temperature is, the faster the head's temperature will

increase.

When it is time to put the Nomad

(usually 10–20 min) or protect hands (with work gloves or a cloth) when

adjusting the Light Head.

reaches a full charge in approximately 7 hours. (Charge time

to warm up to above 10°C/50°F before charging.

back into the Stored Position. Lower the

Poles by untightening the Tripo-Scope

depends on "ambient air" for cooling of its Light Head. After

360 using a soft washcloth, clean water

Poles.

and store.

360 Heatsink Fins (which help disperse

away , either wait for the unit to cool off

is unused for 60 to 90

Tightening Rings.