Daitsu ADD20 사용 설명서 - 페이지 5

{카테고리_이름} Daitsu ADD20에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daitsu ADD20 12 페이지.

Operation

Switch function

1. "1/0" switch

Press the switch once to start operation, press it again to stop operation.

2. "

"switch

Each time the switch is pressed, the operation mode changes in the order of "DEHUMIDIFY",

"LAUNDRY" and "QUIET" and the corresponding mode indicator lamp will change with the opera-

tion mode.

3. "

"switch

Press the switch to set the humidity of the room, which can be set in order of "50%", "60%" "70%" and

"continuous", and the corresponding humidity indicator lamp will lights to display your setting humi-

dity. When the relative humidity of the room is lower than your setting humidity, the operation will stop

automatically. After the operation is started, the default operation mode is the continuous mode, the

operation is continuous in the continuous mode until the unit is stopped or automatically stopped for

the drainage tank is full.

Operation

1. Plug the power supply plug into the outlet and press the "1/0" switch

220~230 V

2. Open the louver by hand

• Use single phase 220~230V AC power supply.

• Wipe dust off of the power supply plug and insert

• Never scratch, cut, or damage the power supply cord.

• After the power supply plug is plugged into the

• Before operation runs, please check and make

- 39 -

the plug firmly, all the way to the rubber section,

if there is a dust on the plug, or the plug is not

fully inserted in the outlet, electrical shock and/or

fire may result.

outlet, "

" lamp will light.

sure the louver has been opened, or it will result

in the temperature of the unit too high and cause

accident. (There are 6 levels to be chosen.)