Anslut 002-657 사용 설명서 - 페이지 11
{카테고리_이름} Anslut 002-657에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anslut 002-657 11 페이지. Led floodlight
Anslut 002-657에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)
페이지 인쇄
DESCRIPTION
1.
Handle
2.
Power switch with two power levels I / II
3.
Stand
4.
Reflector
FIG. 1
USE
CHARGING THE BATTERY
Charging 230 V
1.
Connect the USB cable to the mains adapter
and connect the other end of the cable to
the micro USB port on the spotlight.
FIG. 2
2.
Connect the mains adapter to a power
point.
3.
The red status light inside the charge
connector on the spotlight goes on during
the charging. When the battery is fully
charged the green status light goes on.
NOTE:
•
The product must be switched off when
charging.
•
Charge the battery before using it for the
first time.
Charging 12 VDC
1.
Connect the USB cable to the charger for
12 V vehicle socket and connect the other
end of the cable to the micro USB port on
the spotlight.
2.
Connect the charger to a 12 V vehicle
socket.
3.
The red status light inside the charge
connector on the spotlight goes on during
the charging. When the battery is fully
charged the green status light goes on.
NOTE:
•
The product must be switched off when
charging.
•
Charge the battery before using it for the
first time.
HOW TO USE
1.
Select the required run mode with the
switch. Mode I is full luminous flux (360
lm). Mode II is reduced luminous flux
(140 lm).
2.
Choose the required position on the
handle by pushing in the button and
turning the handle up/down.
FIG. 3
MAINTENANCE
Clean the spotlight when necessary with a soft,
dry cloth.
BATTERY
•
Do not allow the battery to fully discharge.
Over-discharging reduces the life span of
the battery.
•
To avoid the battery becoming completely
discharged, recharge it every three
months even when the spotlight is not in
use.
EN
11