Anslut 009370 사용 설명서 - 페이지 15
{카테고리_이름} Anslut 009370에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anslut 009370 15 페이지.
페이지 인쇄
2.
Remove the bracket from the lamp
housing.
FIG. 2
FIG. 3
3.
Use the bracket as a template to mark
out the mounting holes and drill holes in
these marked positions.
FIG. 4
4.
Put expander plugs in the holes. Screw on
the bracket.
FIG. 5
FIG. 6
5.
Connect the live wire L (brown), neutral wire
N (blue) and earth wire (yellow/green).
FIG. 7
FIG. 8
FIG. 9
6.
Fit the lamp housing on the bracket.
FIG. 10
7.
Make sure that the lamp housing has the
required angle.
FIG. 11
8.
Connect the power supply.
FIG. 12
NOTE:
•
If the spotlight is mounted on a wall
with cover boarding, fillets etc. the
bracket must be placed on a cover board
or a board mounted on two cover boards
or fillets. If the wall bracket is mounted
between two cover boards or fillets, as
in the first diagram, it may not be
possible to turn the spotlight properly.
FIG. 13
•
The product is only intended to be
mounted on a wall. The maximum
mounting height is 3 metres.
USE
Adjust the angle of light beam, if necessary. Be
careful not to damage the product. The product
clicks when adjusted. This is completely normal.
FUNCTIONS
1.
Press once (the status light (diagram 15)
flashes once): The spotlight goes on with
the tracking function when movement is
detected in the dark.
2.
Press twice (the status light (diagram 15)
flashes twice): The spotlight goes on with
the tracking function when movement is
detected, both in the dark and in daylight.
3.
Press three times (the status light
(diagram 15) flashes three times): The
spotlight goes on without the tracking
function when movement is detected in
the dark.
4.
Press four times (the status light (diagram
15) flashes four times): The spotlight goes
on without the tracking function when
movement is detected, both in the dark
and in daylight.
FIG. 14
FIG. 15
5.
The PIR sensor has three detection areas,
one straight ahead, and one on each side.
When the tracking function is activated
and someone or something moves past
the spotlight the spotlight goes on and
follows the movement.
FIG. 16
MAINTENANCE
Clean the product with a damp cloth. Only use
a mild detergent. Do not use solvent or caustic
chemicals.
EN
15