Anslut 004259 사용 설명서 - 페이지 10
{카테고리_이름} Anslut 004259에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anslut 004259 12 페이지. Solar cell lamp
페이지 인쇄EN
SAFETY INSTRUCTIONS
•
The lamp is intended for outdoor use.
•
Store the lamp indoors during the winter.
•
Place the lamp on a level, stable surface.
The glass shade on the lamp is sensitive to
knocks and blows.
•
If the glass gets broken the complete lamp
must be discarded.
•
The lamp is only intended to run on a
battery.
•
When replacing the rechargeable battery
use a battery of the same type as the
original.
•
The lamp is not intended to be used as
general lighting.
•
The lamp is not intended to be used by
children.
•
The LED cannot be replaced. If the LED
stops working the lamp must be
discarded.
TECHNICAL DATA
Battery
Protection rating
Safety class
USE
The built-in rechargeable battery is charged
from the solar cell in the glass. The lamp
switches on automatically when it goes dark,
and switches off when it gets light. During
long periods of insufficient sunlight the battery
will not be charged enough to run the lamp
continuously. This does not mean that the
product is defective. The lamp will shine again
after some sunny days.
10
1 x 1.2 V / 300 mAh AAA
IP44
Positioning
•
Place the lamp in a sunny area without
shadows, standing on a table or other
suitable surface in the garden. Make sure
that the lamp is stable and cannot be
blown over.
•
The lamp is weatherproof, but should be
stored indoors during the winter.
How to use
1.
Remove the lamp from the packaging.
2.
Put the power switch in the ON position.
The power switch is located underneath
the lamp.
BILD 1
3.
A steady white light is activated when the
power switch is in the middle position.
In the outer position the light changes
colour.
OBS!
How long the lamp stays on depends on the
strength of the sunlight during the day. After
days of weak sunlight, or no sunlight at all,
the lamp will shine for a shorter time. If the
III
lamp does not shine the first evening, wait
for a sunny day.
MAINTENANCE
Batteries in solar cell lamps usually need to be
replaced every other year. Only use batteries of
the recommended type.
1.
Put the power switch in the OFF position.
The power switch is located underneath
the lamp.
2.
Unscrew the four screws holding the
battery cover.
3.
Remove the battery cover.
4.
Take off the seal.