DSC PowerSeries PC1864 설치 매뉴얼 - 페이지 13

{카테고리_이름} DSC PowerSeries PC1864에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries PC1864 20 페이지. System enhancement module
DSC PowerSeries PC1864에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 매뉴얼 (18 페이지)

페이지 인쇄

LEDs

The Alarm.com Module LEDs can be used to indicate communication

errors, panel communication, network communication, and signal strength.

BOTTOM OF ALARM.COM MODULE

LED

FUNCTION

Error LED: L1 will flash 1 to 8 times in a four-second interval

to indicate specific error conditions such as a network error,

panel communication error, or radio error.

Panel communication LED: L2 flashes every time a data

packet is received from the panel.

Cellular communication LED: L3 flashes every time a data

packet is received from the cellular radio.

Cellular signal level LED: L4 flashes 0 to 5 times indicating

the cellular signal strength, or toggles on/of f when

communicating with the Alarm.com servers.

Z-Wave Error LED: Visit the Dealer Website Support

Resources for additional Z-Wave installation resources.

LED L1 (RED)

L1 flashes when an error is encountered. The number of flashes indicates

the error number. If there are two or more errors at the same time, the

errors will flash one after the other. The LED will stay off for at least four

seconds between errors.

LED L1 ERROR DESCRIPTIONS AND SOLUTIONS

Alarm.com module cannot communicate with the panel.

Perform a power cycle on the panel. If the error persists

lift the Alarm.com module out of the SEM circuit board and

re-insert it, while power is disconnected from the system.

2 then 4

The Alarm.com module provisioning process could not be

completed. If the error persists, power cycle the system,

then contact Technical Support.

2 then 5

The Alarm.com module provisioning process could not be

completed because the module is currently roaming off the

carrier's primary network.

The Alarm.com module is trying to register on the cellular

network. If it persists for more than a few minutes, the

module is having problems registering. Check L4 for signal

level. If signal level is lower than 2 bars, change the panel's

location or use a remote antenna option.

System

Enhancement

Module (SEM)