Foxpro HELLFIRE 사용 설명서 - 페이지 12

{카테고리_이름} Foxpro HELLFIRE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Foxpro HELLFIRE 20 페이지.

To connect the speaker:

Make sure the Hellfire is turned off.

Connect the plug from the external speaker into the external speaker jack.

Proceed with normal operation.

6. TX9 Detailed Information

The Hellfire features the TX9 remote control. The TX9 features a graphic display, two custom

preset buttons, volume level indicator, elapsed tier, and more.

IMPORTANT NOTE

The Hellfire remote control is not intended to operate the caller at distances

shorter than 1 meter (3 feet). If the remote is located too close to the caller,

proper operation cannot be ensured.

The recall button remembers the last sound and volume level that you were operating with. For

example, if you are playing sound 001 at volume 9, and then switch to sound 002 at volume 5,

by pressing the recall button you will jump back to sound 001 and volume 9.

The elapsed timer allows you to see how long you have been on a stand. The timer starts as

soon as you turn on the TX9 transmitter. You can reset the timer by pressing the Auxiliary and

Sound Up buttons simultaneously. The timer will automatically reset to 00:00 if it is allowed to

continue beyond the 99:59 mark.

When enabled, FOXBANG will play your first preset sound upon discharging of your firearm. For

example, if you normally switch to a preset of a ki-yi or pup distress after making a shot,

FOXBANG can automatically play that preset for you without the need for intervention.

FOXBANG has 5 sensitivity

levels which are set via the

TX-9 transmitter (lowest,

low, medium, high, and

highest). FOXBANG status

will be shown in the upper

left-hand corner of the

display