DSC Power Series 설치 지침 - 페이지 2

{카테고리_이름} DSC Power Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC Power Series 2 페이지. Neo image sensor
DSC Power Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 매뉴얼 (18 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (14 페이지), 빠른 매뉴얼 (4 페이지), 설치 지침 매뉴얼 (11 페이지)

페이지 인쇄

PC5200 Jumper Settings

The PC5200 has 2 jumpers; to select which PC5200 slot is to be used refer

to the table below.

Limited Warranty

Digital Security Controls Ltd. warrants that for a period of twelve months from the date of purchase, the

product shall be free of defects in materials and workmanship under normal use and that in fulfilment of

any breach of such warranty, Digital Security Controls Ltd. shall, at its option, repair or replace the

defective equipment upon return of the equipment to its factory. This warranty applies only to defects in

parts and workmanship and not to damage incurred in shipping or handling, or damage due to causes

beyond the control of Digital Security Controls Ltd. such as lightning, excessive voltage, mechanical

shock, water damage, or damage arising out of abuse, alteration or improper application of the

equipment.

The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other

warranties, whether expressed or implied and of all other obligations or liabilities on the part of Digital Security

Controls Ltd. This warranty contains the entire warranty. Digital Security Controls Ltd. neither assumes, nor

authorizes any other person purporting to act on its behalf to modify or to change this warranty, nor to assume

for it any other warranty or liability concerning this product.

In no event shall Digital Security Controls Ltd. be liable for any direct or indirect or consequential damages,

loss of anticipated profits, loss of time or any other losses incurred by the buyer in connection with the

purchase, installation or operation or failure of this product.

Warning: : : : : Digital Security Controls Ltd. recommends that the entire system be completely tested on a

regular basis. However, despite frequent testing, and due to, but not limited to, criminal tampering or

electrical disruption, it is possible for this product to fail to perform as expected.

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your

authority to use this equipment.

This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance

with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested

and found to comply with the limits for Class B device in accordance with the specifications in Subpart "B" of Part

15 of FCC Rules, which are designed to provide reasonable protection against such interference in any residential

installation. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause interference to television or radio reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

•

Re-orient the receiving antenna

•

Relocate the alarm control with respect to the receiver

Move the alarm control away from the receiver

•

Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.

The user may find the following booklet prepared by the FCC useful: "How to Identify and Resolve Radio/Television

Interference Problems". This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402,

Stock # 004-000-00345-4.

SLOT

PC5200 1

OFF

PC5200 2

PC5200 3

OFF

PC5200 4

Toronto, Canada

1-800-387-3630 • www.dsc.com

Printed in Canada

OFF

29005251 R001