DSC PowerSeries 사용자 설명서 - 페이지 10

{카테고리_이름} DSC PowerSeries에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PowerSeries 20 페이지. Telephone interface & automation control module
DSC PowerSeries에 대해서도 마찬가지입니다: 제품 요약 시트 (20 페이지)

페이지 인쇄

To select a Bypass Group when arming the system:

1. Press

, then your [access code] (if necessary).

2. Press

. The next time the system is armed, the zones in this group will be bypassed.

3. To exit bypassing mode and return to the Ready state, press

NOTE: A Bypass Group is only recalled if the system is armed/disarmed after programming the by-

pass group.

NOTE: This feature is not to be used in UL Listed installations.

Trouble Conditions

When a trouble condition is detected, the Trouble ( ) indicator will turn on, and the keypad will

beep every 10 seconds. Press the

dition. The Trouble ( ) indicator will flash. Use the

Trouble

Condition

Service Required

(Press [1] for more

information)

Loss of AC Power

Telephone Line

Fault

Failure to

Communicate

Sensor (or Zone)

Fault

Sensor (or Zone)

Tamper

Sensor (or Zone)

Low Battery

Loss of Time & Date

Alarm Memory

When an alarm occurs, the Alarm Memory Message will be displayed. To view which sensor(s) gener-

ated the alarm, press

For the system keypad use the

Press

to exit. To clear the memory, arm and disarm the system.

If an alarm sounded while armed, the system will automatically go to alarm memory when you dis-

arm the system. In this instance, you should approach with caution, as the intruder may still be within

the building/premises.

Door Chime (Entry/Exit Beeps)

To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press

. The system will sound three beeps to indicate the door chime is on or one long tone to

indicate that the feature is off.

key to silence the beeps. Press

Indicates Low Battery, System Trouble, System Tamper or

RF Jam detected.

If the building and/or neighbourhood has lost electrical

power, the system will continue to operate on battery for

several hours.

The system has detected that the telephone line is dis-

connected.

The system attempted to communicate with the moni-

toring station, but failed. This may be due to Telephone

Line Fault.

The system is experiencing difficulties with one or more

sensors on the system. Press [5] to display zone(s).

The system has detected a tamper condition with one or

more sensors on the system. Press [6] to display zone(s).

If the system has been equipped with wireless sensors,

one or more has reported a low battery condition. Press [7]

to display the zone(s). Press [7] again to display WLS keys.

If complete power was lost (AC and Battery), the time

and date will need to be re-programmed. Press [*]

scroll keys to view the sensors in alarm memory.

keys to view troubles.

Comments

to view the trouble con-

Action

Call for service

Check AC

connection

Call for service

Re-program Time &

Date (page 4)