ANSMANN BARCELONA 사용 설명서 - 페이지 7
{카테고리_이름} ANSMANN BARCELONA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ANSMANN BARCELONA 7 페이지.
페이지 인쇄automatic range alarm:
The babyphone is equipped with an acoustical and optical range alarm.
This range alarm function gives you the safety to be immediately
informed, if the connection between transmitter and receiver is
interrupted.
The indicator "Range alarm" (17) gives signal if there is no connection
between transmitter and receiver. In addition an acoustical alarm gives
signal if there is a failure. With the switch "Range Alarm" (18) the
acoustical alarm can be switched on or off. Undependent of the switch
position the indicator "Range alarm" (17) is blinking when there is no
connection between transmitter and receiver.
Possible reasons for "range alarm":
> Transmitter is not switched on
> Low battery power of the transmitter
> Power adapter of the transmitter is not contacted
> Coding of transmitter and receiver is different (see 23)
> Distance between transmitter and receiver too high
expansion of the aerial:
You can open out the aerial of transmitter and receiver by pressing the
button "Antenna" (19) on the rear side of the unit to increase the range
and guarantee an good connection between transmitter and receiver. If
there is a short distance between transmitter and receiver it´s no need
to open out the aerials for good connection.
adjustement of the transmission power:
The transmitting power of the babyphone can be adjusted by the switch
"Transmission Power" (20) on the underside of the transmitter in two
steps (Hi/Lo).
Switch position "Hi": max. transmitting power
Switch position "Lo": reduced transmitting power
reset function:
At possible malfunctions open the battery compartments of transmitter
and receiver and activate an reset by pressing the buttons "reset" (21)
of transmitter and receiver.
mobile use:
Transmitter and receiver are equipped with a belt clip (22) for mobile use.
WArrANtY
We hereby issue a warranty for a period of 3 years subject to the therms
and conditions listed below.
No warranty claim will be accepted for the following cases:
> Operating error
> Wrong coding / wrong channel selection (see 23)
> Failure due to other radio installations (e.g. mobile phones)
> Interference from outside
> mechanical damage due to mishandling
> humidity damage
> no proof of purchase receipt to validate claim
> low power or faulty batteries
iMPOrtANt NOtE
Information for use as a monitoring system for vulnerable children or
persons. This system cannot replace personal supervision of a child or
person requiring care, but will only support it. We don´t accept any
kind of consequential liability outside that the legal product warranty
regulations. This applies in particular for medical use of this system for
which it is not intented.
cOMPlEtE sEt iNcludEs
1 x transmitter
1 x receiver
2 x power adapter
1 x 3,6 V NiMH battery pack
1 x multilingual operating instructions
tEcHNicAl dAtA
Channels: 16 channel by digital coding
Frequency 1: 40.665 MHz
Frequency 2: 40.695 MHz
Max. transmitting range:
300 m (free field measurement )
Mobile transmitter:
4 x Micro AAA
Mobile receiver:
3.6 V NiMH battery pack
Mains operation of transmitter/receiver:
2 x power adapter DC 9 V/200 mA