DSE DK-BK1 소유자 매뉴얼

{카테고리_이름} DSE DK-BK1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSE DK-BK1 3 페이지. Camera and vcr in the book / agenda

OWNER'S MANUAL
DK-BK1
Camera and VCR in the book / agenda

Product description

DK-BK1 is a book / calendar that contains a hidden camera with video recorder.
The product is also equipped with a highly sensitive microphone can sense very clearly all the
sounds of the environment, including phrases spoken softly in a medium sized environment.
DK-BK1 is equipped with a powerful internal battery without power for an autonomous operation
for a long period. In addition, thanks to the PIR motion sensor can monitor an environment for
days and begin recording only in case of intrusion.
DK-BK1 is also equipped with infrared illuminator for shooting in the dark up to 6 meters
Design unsuspected
In order not to arouse any kind of suspicion DK-BK1 is a real agenda to pull sheets rings where
you can enter any your document.
CAUTION: PIR sensor and IR illuminator are covered by a protective film that MUST NOT BE
CAUTION: PIR sensor and IR illuminator are covered by a protective film that MUST NOT BE
REMOVED , Since its purpose is to camouflage these elements with detection of the object
REMOVED , Since its purpose is to camouflage these elements with detection of the object
material.
Controls
The DVR control panel is located within the agenda
1 - Slot for Micro SD card 2 - to reset button
3 - USB port for PC (cable supplied) 4 - LED status
indicators
5 - Selector for audio recording (ON / OFF) 6 - Ignition Switch and recording
type (MD = motion REC = continuous OFF = off)
Battery powered
DK-BK1 is made to work with its internal battery. E 'equipped with a battery of large capacity (10
Ah) hidden inside the calendar cover that allows up to 30 hours of continuous recording (10 hours
with IR illuminator access).
DSE srl - Digital Surveillance Equipment - www.dse.eu
DK-BK1 camera with video recorder on the agenda
Thanks to its motion sensor, DK-BK1 can also stay up to two years waiting for an intrusion to
start recording.
Charging the internal battery
DK-BK1 is provided with a built-in battery from 10000 mAh which allows the DVR to record for 30
consecutive hours.
The battery is always connected so that you can turn on your DVR at any time. The battery is
charged when supplied, but it can have its own minimum consumption even if the product is not
used. For this reason it is recommended that as first thing to provide battery charging, just
received the product. To recharge the battery just connect the USB plug to a computer or to a USB
charger with the supplied cable. While charging is advisable to maintain the power switch to OFF.
YELLOW LED lights to indicate charging in progress.
To recharge a completely discharged battery takes about 20 hours. Once charging is complete,
the yellow LED turns off.

Inserting the micro SD card

To register you must insert a micro SD card into the slot (Figure 1). E 'can use micro SD card with
a capacity of 4 to 128 GB CLASS 10 or higher. An SD card class 10 has a 10 MB / s write speed.
a capacity of 4 to 128 GB CLASS 10 or higher. An SD card class 10 has a 10 MB / s write speed.
a capacity of 4 to 128 GB CLASS 10 or higher. An SD card class 10 has a 10 MB / s write speed.
Do not use the SD card with a lower rate because it would lead to malfunction. Attention to the
SD card inserting direction that will slide in its seat only with the gold contacts facing upward, as
shown in silhouette drawn to the left of the slot.
The SD card should be pushed into the slot with the nail until you feel the retaining snap. To pull it
must not pull it outward, but push again until you hear the unlocking.
The package does not include any Micro SD card that you need to be purchased separately
according to your need for storage.
Be advised that DK-BK1, recording in FullHD, occupies a lot of memory: about 1 GB every 8
minutes. On a 32GB SD card you can hold over 4 hours of recording. On an SD card of 128 GB
over 16 hours. Typically this product is used in motion detection, so as to occupy only memory in
case of intrusion.
Overwrite
Once you run out of space in the DVR factory memory begins to overwrite the old files and
continue to register. It can also set the stop at full disabling memory overwrite (see below)
Signaling LED
DK-BK1 is equipped with a 3 LEDs that indicate the status.
STATE OF THE LED
MEANING
Solid yellow
DVR connected to PC or power supply
OFF switch. Battery charging.
Solid yellow Blue / red
DVR connected to PC with ON switch. Battery charging
flashing
and reading SD card with PC.
Document: DK-BK1-1I6
Document: DK-BK1-1I6
Document: DK-BK1-1I6
Page: 1
Page: 1
USB
with