ATsens AT-Patch 사용자 설명서 - 페이지 3

{카테고리_이름} ATsens AT-Patch에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATsens AT-Patch 14 페이지.
ATsens AT-Patch에 대해서도 마찬가지입니다: 빠른 매뉴얼 (2 페이지), 빠른 매뉴얼 (6 페이지), 사용자 설명서 (14 페이지)

페이지 인쇄
ATsens AT-Patch 사용자 설명서
How to attach the device
Checking the area to attach the device
1
Draw an imaginary line between the middle of the two clavicles and
left nipple, and check the position to ensure the device is attached
to the center of the area.
Shaving and exfoliating the device attachment area
2
If there is a lot of chest hair in the area where the device will be attached,
use a razor to remove the chest hair and remove foreign substances such
as dead skin cells.
Cleaning the area where the device will be attached with alcohol
3
1) Clean the attachment area with an alcohol swab for at least 1 minute.
2) Clean with alcohol and dry for at least 2 minutes.
4
02
How to use the device
4
5
Power Button
(3 seconds)
6
My ECG
Detaching the Film & Attaching the device
Detach the device from the transparent protective film. And attach
the device with the side marked with "
Up" facing upwards.
▲

Turning on the power

Press the power button of the device for more than 3 seconds and
the color of the button will change to green, flash 3 times, and make
a sound.
Checking the ECG signal
1) After attaching, check the signal status in AT-Note App.
(Reattachment 1~2 times possible if the signal would be poor.)
2) After confirming the signal, press the entire area of the device for
at least 10 seconds so that the device adheres well.
02
How to use the device
5