DSPPA DMA6250U 사용자 설명서 - 페이지 11

{카테고리_이름} DSPPA DMA6250U에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSPPA DMA6250U 14 페이지.

6. FM Mode

For button description, please refer to the instructions in "Front Panel" above, sections 20, 22 and 23. Press

MODE button until the digital screen displays FM to enter FM mode, as shown below; Then it will start to play

radio programs.

Searching radio stations: Before playing, search radio stations first, the FM band radio frequency range is

87.00MHz - 108.00MHz.

Methods of searching for Radio Stations: Short press button

automatically from low to high frequency bands. The searched stations will be stored in number starting with

1, so that the stations can be recalled directly later.

Calling radio stations: search and store good radio channels with automatic search method, and you can call

and play them directly. Press button"

press number "0-9" to play.

7. 6-zone Control Switch

Short Press the button FN to enter the zone setting interface, and the "1", "2", "3", "4", "5" and "6" buttons on

the panel can be used to turn on or off the corresponding zones as shown in the figure below. Press and hold the

FN button for more than 1s to open all zones. At the same time, the indicator lights at the 6 zone volume

adjustment knobs on the device panel display bright blue, and then press again to back to the state it was in before.

8. Adjust Volume of Audio Source

Volume of 6 zones/MIC1/MIC2/MIC3/LINE1/LINE2/LINE3 can be adjusted directly through the



corresponding volume knob on the panel.

Volume of MIC4/LINE4, EMC, Chime, SIREN: long press the LOOP volume adjustment button to enter the



volume setting interface, then short press the LOOP button again and select MIC4/LINE4, EMC, Chime,

SIREN alarm setting interfaces, press button "V+/ V-" to adjust the volume of the corresponding audio

source through the panel(0-32).

"on the panel to choose radio stations you want to play, or

on the panel or remote control to search